齿轮传动的设计计算.docVIP

齿轮传动的设计计算 FA “ c vx 1^ ^lz £ 1^ sl^ sl^ £ 1^ sl^ xl^ 1^ xl^ 1 sl^ III I 1 Pl 二 22; N1 二 970; I = 3. 5; K = 1.4; Hd = PI / 180; Ha 二 1.0; Ca 二 0. 25; M 二[2, 2. 5, 3, 4, 5, 6, 8, 10, 12, 16, 20, 25, 32, 40, 50] The % first selects the first series Disp (note: the id of the type of gear and the hardness of the teeth below is capitalized and enclosed in single quotation marks) CL = input ( select gear materials: carbon steel - TG; alloy steel - HG 二二’)； CM = input ( select tooth surface hardness class: hard tooth surface - YC; soft tooth surface - RC 二二)； The selection reference for the disp ，tooth width factor/ The disp J symmetrical arrangement 一 0.8一1.4 soft teeth; Hard teeth 0. 4 to 0. 9 Dissymmetrical arrangement 一 0.6一1・ 2. Hard teeth 0. 3 to 0. 6 The disp J cantilever arrangement 一 the soft teeth 0.3 to 0.4; Hard-tooth surface 0.2一0・ 25 Fd 二 in put ( select tooth width factor: Fd 二)； Disp 二二二二二二二二二二 二二二二二二 二二二 二二二 Fprintf (1,active wheel transfer power Pl = % Fprintf (1, Pl) Fprintf (1, active wheel speed nl 二 ％ 3.3 f r/min \ n，, nl) Fprintf (1, the transmission ratio I = % 3・ 3 f \ n, I) Fprintf (1, Toad factor K = % 3. 3 f \ n，, K) Fprintf (1, the high tooth coefficient ha * 二 ％ 3. 3 f \ n , ha) Fprintf (1, 〃the gap coefficient c* = %3 ・3f\n, Ca) Fprintf (1, the tooth width coefficient Fd = % 3・ 3 f \ n, Fd) Disp (note: the following input is the value of heat treatment hardness) If CL 二二TG， Disp gear material - carbon steel If CM 二二YC Disp sclerodac-stiff—teeth IIRC1 二 in put ( in put pin ion hardness IIRC1 二)； HRC2 二 input ( big gear induction hardening hardness HRC2 二 CHM1 is 11 times HRC1 plus 610; CHM2 is equal to 11 times HRC2 plus 610. CFM1 二 380; CFM2 二 380; Elseif CM 二二，RC‘ Disp tooth surface hardness， - soft tooth surface HBS1 二 input ( input pinion/HBSl 二’)； HBS2 二 input ( large gear tuning/HBS2 二’)； CHM1 is (9 * HBS1 + 3750) / 10; CHM2 二(9 * HBS2 + 3750) / 10; CFM1 二(2 * HBS1 + 675) / 5; CFM2 二(2 * HBS2 + 675) / 5; The end Elseif CL 二二，HG，