drager evita 4 and 2 dura service manual 英文维修手册7.pdfVIP

7.10 Monitoring the operating voltages The operating voltages accessible via an A/D converter are compared cyclically with the defined tolerances of +/- 20%. A hardware malfunction is reported if these tolerances are exceeded for more than 5 s. 7.11 Monitoring the gold cap voltage In the event of a power failure, the gold cap supplies a voltage to the piezo alarm tone generator, thus issuing a pas failure alarm. The duration of this power failure alarm depends on the capacitance of the gold cap and, therefore, both functioning and also the capacitance are subjected to a test every hour, for the first time five minutes after activation of the unit. A hardware malfunction is reported if one of the following criteria is fulfilled: a. The final charge voltage is too high (= 11 V) Voltage regulator defective b. The final charge voltage is too low ( 8 V) Charging circuit defective c. The reference voltage is too high (= 6.3 V) Discharge switch defective d. The reference voltage is too low ( 4.5 V) no gold cap e. Voltage of the gold cap has dropped by more than Gold cap capacitance too low 10 % of the reference voltage within 4 s The test of the gold cap is aborted if it is interrupted by piezo alarming (e.g. lamp test or alarm of the safety software). The test is repeated after a recharging time of ten minutes. 7.12 Monitoring the rechargeable battery voltage 7.12.1