内容文本课件文稿rds sharing_qinhuangdao_20160326.pptxVIP

RDS sharing;;;;Rds deployment steps;DOT INSTALLATION;Class Ea/CAT6A cabling scenario;Cable Measurement;rds cabling;rds cabling-WHY 200M?;Sharing of complete end-to-end link Valid for co-located dual band deployments Y-splitters at IRU and DOT end points of CAT cable Sharing of common cable route Valid for Single band non-colocated Dual band deployments Y-splitters for common cable route (eg the vertical riser to IDF) Floor level fan-outs per DOT Daisy chaining (cascading) Valid for any band combination Requires cable route between DOT positions Y-splitter at IRU and first DOT, with cable routed to cascaded DOT ;Y-splitteR;Rds installation;rds INSTALLATION;“DOT” Comparison;Major updates;;Coverage area by each dot;;RDS pZero settings;Pzero is used to control the averaged received UL power at the eNode B and thereby the UL SINR. The default value for pZero that have been used before was intended for a Macro cell. In a small cell scenario, e.g. RDS, the DL power and the UL receiver sensitivity have been reduced compared with a Macro RBS in a macro cell. As a consequence, the pZero values ??must be increased to compensate for the reduction in UL receiver sensitivity To get a normal UE behavior when a UE is camping in a small cell Initial tests have also shown that pZero needs to be raised for RDS. In order to optimize the UL performance in relation to small cell scenario (reduced RX UL sensitivity), it is recommended to increase the default pZero values by 20-23 dB on the RDS. This recommendation will improve the uplink bit rates and uplink throughput. Note: we might need to adjust the pZero values when more test inputs are available. ;DOT Noise Floor explanation;In RDS system, individual RD downlink power control allows the user to reduce the transmit output power for each RD. An IRU command line allows the user to set the gain adjustment reduction on each RD based on user input. By default, the gain adjustment is set to zero, and the RD is running on full power (