毕业设计（论文）-壳体侧抽芯注塑模设计（全套图纸） ..pdfVIP

要 本论文介绍了壳体的注射模设计过程。主要研究带有侧凹或侧孔结构的塑料 制件如何分型和脱模的，本塑件侧面带有三个小孔，直接开模无法实现分型，这 就涉及到斜导柱和斜滑杆的设计以及他们的工作原理，利用注塑机开合模的作用 力进行侧抽芯，一方面减少了一些零件的使用，降低成 ；另一方面省去一些零 件的安装工序，节约时间，缩短生产周期，提高经济效益。本文还介绍了型腔数 量和布局的确定、注射机选择、浇注系统设计、模板及其标准件的选用、脱模及 抽芯机构的设计、成型部件的设计等。 关键词 注塑摸；斜滑杆；侧抽芯；壳体 全套图纸，加153893706 ABSTRACT This paper has introduced the design process of inj ection mould of the shell. The main research the plastic workpiece with side concave or side hole is how to divide structure and draw of patterns. Because the side of model has three eyelets, it is 1 unable to realize by directly operating the mold, by designing the slanting leader pin and the lifter. We use the action of the inj ection molding machine to carry on core-pulling. The advantage of this design are reducing the use of some components, lowing the cost, omitting some component to install the working procedure, saving time, reducing the production cycle and enhancing the economic efficiency. This article also introduces die space quantity and the layout determination, the inj ection machine choice, the casting system design, the template and the standard part selection, the drawing of patterns and core-pulling organization design, the formation parts design etc. Key words:inj ection mould; lifter; core-pulling; shell 录 1 前言4 2 绪论5 2.1 概述5 2.2 我国塑料模现状6 2.3 我国塑料模的发展趋势6 3 塑件成型工艺分析8 3.1 塑件图8 3.2 塑件工艺分析8 3.2.1 精度等级8 3.2.2 脱模斜度9 3.2.3 塑件圆角9 3.3 ABS 塑料性能特性与工艺参数9 3.3.1 ABS 化学与物理特性9 3.3.2 ABS 塑料的成型条件 10 4 拟定模具结构形式 11 4.1 型腔数目的确定 11 2 4.2 分型面的选择 12 5 注塑机型号的确定 14 5.1 注塑容量的计算 14 5.2 锁模力的计算 14 5.3 注塑机的选用 15 5.4 有关参数的校核 16 5.4.1 由注塑机料筒速率校核模具的型腔数 16 5.4