毕业设计（论文）-某中级轿车前制动器设计.docx

PAGE \* ROMAN PAGE \* ROMANII 某中级轿车前制动器设计 摘要 本文的设计题目为某中级轿车前制动器设计与分析，所以选择了奥迪 a52019 款的一辆车，该种车型排量为 1980ml，为典型的中级轿车。在对其前制动器进行设计与分析之前，首先对中级轿车前制动器的研究背景进行了调查，发现中国的制动器的制造技术仍有待提高，所以本文对于中级轿车前制动器进行设计与分析具有特殊意义。由于是前制动器，所以我选择了通风盘式制动器，并且采用了浮动钳盘式制动器，在网上查阅了奥迪 a5 的满载质量，质心位置，轮胎规格等参数，对制动器的进行了相关力学分析，主要利用理论力学知识进行了设计计算 ，并根据计算结果选取了同步附着系数以及对最大制动力矩进行了计算，本文对奥迪 a5 前制动器相关尺寸进行了设计，接着进行了其他主要制动器元件设计，根据设计内容画出对应的三维图和二维图，在三维图和二维图中对加工要求和具体尺寸给出了更加详细的标注，最后进行了温升等校核和进行了最后的性能分析。 关键词：盘式制动器；设计与分析；前制动器；制动性能 全套图纸加扣 3346389411或3012250582 Design and analysis of an intermediate car front brake Abstract The design title of this paper is the design and analysis of the front brake of an intermediate car, so I choose a car of audi a52019 model. The displacement of this model is approximately two liters, which is a typical intermediate car.Before the design and analysis of the front brake, I first investigated the research background of the intermediate car front brake, and found that the manufacturing technology of Chinas brake still needs to be improved, so this paper is of great significance for the design and analysis of the intermediate car front brake.Being front brakes, so I chose the ventilated disc brakes, and used the floating caliper disc brake, I looked at the audi A5 online full quality, centroid position, the tire specifications, parameters, such as on the brake of the related mechanics analyses, the main design and calculation are carried out using theoretical mechanics knowledge, and selected the synchronous adhesion coefficient according to the results of the calculation and calculation of the maximum moment, in this paper, the audi A5 brake before designing relevant sizes, and then the other main brake components design, according to design class should draw the corresponding three-dimensional figure and 2 d figure,In the three- dimensional and two-dimensional diagrams, the machining requirements and specific dimensions are marked in more detail. Finally, the temperature rise is checked and t