★aqwa中文帮助解析.pdf

ANSYS TO AQWA MODEL TRANSLATOR ANSYS模型文件转换 AQWA-LINE标准输入文件 1. INTRODUCTION引言 It is possible to use classic ANSYSto create an AQWAradiation/diffraction model. Any of the tools available in Workbench or ANSYScan be used to create the model. Once the model is created an AQWA input file can be written out using a macro supplied with ANSYS. 使用传统的 ANSYS产生 AQWA辐射 / 绕射模型是可行的。在 Workbench 或 ANSYS中有 工具能够建模。一旦模型建立了，使用 ANSYS的宏命令 ANSTOAQWA可以自动产生 AQWA-LINE的输入文件（将 .aqwa 修改为 .dat 格式即可）。 2. MODEL DESCRIPTION模型描述 The model must be meshed with the mesh that you wish to use for the AQWA analysis. If you are working from a model created for a structural analysis, it will probably be necessary to re-mesh the model as the structural mesh is likely to be finer than is need for a diffraction analysis. 必须使用与 AQWA中分析单元类型相同的单元来划分模型的网格。 如果你的模型建于 ANSYS结构分析，可能会需要不断重新划分网格直到网格尺寸、数目等满足绕射分 析的要求。 There should be a line of nodes at the waterline, although these nodes do not need to coincide with nodes on the structural model. The translation macro will only make diffracting those elements that are entirely below the waterline. If there are no waterline nodes there will be no diffracting elements at the waterline, which will severely reduce the accuracy of the diffraction analysis. 吃水线上应该有一行节点，尽管这些节点不需要符合结构模型的节点。 转换宏会仅 仅将位于吃水线以下的单元制作成绕射单元 （DIFF）。如果没有吃水线节点， 则吃水 线上不会有绕射单元，这会严重的减少绕射分析的准确性。 All the panel elements below the water must have their normals pointing outwards. 水下所有的面元必须指示外表面。 In AQWA the vertical axis is always the Z-axis. The translator can convert a model with either Y or Z-axes vertical, but the X-axis must be horizontal and preferably should be along the fore/aft axis of the vessel. 在 AQWA中垂向轴总是 Z 轴。转换器能转换一个以 Y 或 Z 为垂直方向的模型，但是 X 轴必须是水平方向的，