焊接通用要求.docVIP

焊接通用要求 Welding procedure together with the relevant procedure qualification and non-destructive testing procedure shall be provided for pressure vessels. Heat treatment procedure may be indicated in the welding procedure or submitted as separate documents. Welding procedure and welder’s qualification shall be according to ASME code. Welding shall be performed by qualified welders using qualified procedures and test and inspection shall be performed by qualified inspectors using qualified procedures, according to applicable ASME code. The identification of the welders must be applicable for the following critical piping: HP steam pipe (from(SH) outlet to ST HP stop valve); Low temperature reheat steam pipe (from ST HP exhaust to (RH) inlet); High temperature reheat steam pipe (from (RH) outlet to ST RSV). The welding material shall be similar to the mother material according to applicable code. Welding plant and ancillary equipment shall be in accordance with the appropriate parts of BS 638 or equivalent international standard. The area of the temporary welded attachments shall be examined according to applicable code if the parts will be used as removed. The material composition to be welded shall be according to applicable material code. Preheat condition for shop and field welding shall be in accordance with applicable code. NDT of castings, wrought products and welding shall be carried out in accordance with the applicable material code/standard or British Standard. NDE procedure for the owner’s witness items shall be submitted for approval. SNT-TC-1A shall be applied for NDE operator/inspector qualification. NDE operator shall be Level I, and inspector shall be Level II. During the detailed design stage, the boiler manufacturer shall submit for approval the welding procedure specification (WPS) and procedure qualification records (PQR’s) and heat treatment procedure for the critical components which are listed below.（卖方负责自己供货范围内焊缝） HP steam pipe (from (SH) out