第一次工程例会纪要.pdfVIP

第一次工程例会纪要 时间 :2014 年 7 月 30 日 地点 : 工地会议室 参会人员 : 详见会议签到单 主持人 : 史杰 议题 :1 、三方相互认识 2、施工单位介绍开工前期准备工作 3、建设单位、监理单位针对本工程情况提出相关要求 4 、研究决定各方参加工程例会的人员，时间及地点 建设单位 : 建设、监理、施工三方要多交流，有问题及时提出解决 1 、 大门的五牌一 图，制度不符合要求，立即整改 2、 资料一定要和实体同步进行，原材料要检测，项目部人员组建 要抓紧时间 3、 前期资料，施工进度计划，开工报告，材料场地什么没有，要 抓紧时间落实。 4 、 设计变更要两级管制，必须经设计同意 5、 作息时间要准时，规章制度我们要共同遵守。 6、 施工单位 : 工程准备情况 :13# 、16#临电二级配电柜安装到位目前班组落实情况基本一落 实到位，临时用电已到位，现场目前还差厕所、门卫、浴室未到位，办公设备布置 到位 to comply with the requirements. (6) pressure pipes are installed according to the design requirements of the system pressure test, segmented tiered when pressure testing to be carried out in sequence, drainage, stormwater pipes to do water testing, and recording, pressure test failed or untested pipeline may not be concealed. Test pressure is the pressure piping installation one stops. (7) the control interface of pipeline leakage from the processing begins. Thread processing to tight fit, length should comply with the requirements. Flange after welding to check end verticality, checking the welding quality. (8) electrical engineering should control the grounding line of weld quality and laying of pipeline quality, timely measurement of grounding resistance, and completes the record. (9) the phase and neutral and ground wire to strictly control the installation location may not be wrong, to multi color lines as required. (10) the distribution box, distribution bottle Shell to a separate ground line, shell transitions can not be used. (C) the pipeline installation engineering 1. construction sequence (1) be familiar with design drawings and related technical information; (2) construction survey and setting out; (3) cooperate with the reserved, embedded civil work; (4) pipe and tube processing (5) support (hanging) production; (6) the pipe prefabrication