本科毕业设计论文--榨汁机内支架塑料模具设计论文.pdfVIP

江南大学 榨汁机内支架塑料模具设计 Plastic mould design of Juice-extractor part 摘 要 模具行业是国民经济的一项重要行业。近年来，模具一直朝着高质量、高效率、 低成本、短周期的方向发展。传统的模具设计中 , 模具设计者们是利用二维 CAD软件 来进行初步设计的。然而，现在，三维模具设计已经被广泛使用，它使设计过程接近 标准化，使初步设计得以迅速实现。在本设计中，将对榨汁机内支架的模具通过 Pro/ENGINEER软件进行三维设计，并对设计过程进行讲解。 在本设计中，首先对塑件结构、材料特性、用途以及参数进行分析，确定模具采 用一模两腔， 并使用点浇口填充型腔的总体布局形式。 在模具设计过程中， 对侧向抽 芯机构，分型面的设计，浇注系统、排气系统、冷却系统、脱模机构，进行了详细的 介绍。最后通过对注塑机参数校核和生产验证，证明模具结构设计合理性。 通过本次模具设计， 可以看出，三维模具设计可以缩短设计周期， 提高设计质量， 大大的增加工作效率。 关键字 ：榨汁机内支架；注塑模具；一模两腔；侧向抽芯机构 1 江南大学 ABSTRACT The die and mould industry is an important industry of the national economy. In recent years, mould is developing towards high quality, high efficient, low cost and short- period. In traditional mould design , mould designers was using 2D CAD Software Tools to proceedthe preliminary design . However, 3D mould design already has been used extensively nowadays, which makes mould design approachto standardization and makes preliminary design quickly realize. In this article, it presents 3D mould design for juice-extractor part by Pro/E, and explains its design process in detail. In this design, at first , it have analyzed the plastic part structure , material properties , use , and parameters , ascertainedthe mould layout form of One to Two cavities , and adopted the general distribution form of pin-point gate filling with cavity. In this mould design process, it has introduced in detail for side Core-Pulling mechanism , the design of parting surface, gating system and venting system, cooling system, ejection mechanism. Finally, through checking and prod