GFSIGNET2350温度传感器操作说明书..docVIP

GFSIGNET2350温度传感器操作说明书. GFSIGNET2350温度传感器操作说明书. PAGE / NUMPAGES GFSIGNET2350温度传感器操作说明书. SIGNET 2820 Series Conductivity Sensor Instruction Manual ENGLISH Wiring Recommended Position 2819/2820/2821 In-line Installation SAFETY INSTRUCTIONS FOR IN-LINE ELECTRODE INSTALLATION 1.Do not remove from pressurized lines.2.Do not exceed maximum temperature/pressure specifications.3.Wear safety goggles or face shield during installation/service.4.Do not alter product construction. Failure to follow safety instructions may result in severe personal injury! Customer supplied pipe tee/reducer Standard fitting kit Hole up Mark hole position 3/4 in. NPT Hand tighten only! Optional fitting kit Hole up Mark hole position Customer supplied pipe tee/reducer 1/2 in. NPT Hand tighten only! O-ring O-ring Sealant Sealant +GF + SIGNET 5800CR ?Use three conductor shielded cable for cable extensions up to 30 m (100 ft max.? Shield must be maintained through cable splice RED WHITE BLACK SILVER (SHLDS h l d S i g n a l I N T e m p . I N I s o . G n d CH 2 CH 1 RED SILVER (SHLD BLACK SILVER (SHLD BLACK C NO Tx GND Rx CH2S2 T2 S1 T1 SG C NO R+ R-RLY3RLY4SERIAL ANL2CH11 2 3 4 5 6 7 8 9 10 11 12 13 14 WHITE RED WHITE +GF + SIGNET 9050CR In-line 2821-1 Use caution to avoid air bubble or sediment trapping inside the electrode cavity. Submersible OR (J-2/03 English 3-2820.090-1 2822 In-line Installation 2823 In-Line Installation Customer supplied pipe tee/reducer 1-1/4 turns past finger tight Hole up Mark hole position Install behind hole ONLY! Customer supplied pipe tee/reducer 3/4 in. NPT 12 1-1/4 turns past finger tight 3/4 in. NPT Customer supplied coupling Customer supplied pipe Sealant 2819/2820/2821 Submersible Installation 2822 Submersible Installation 2 Standard fitting kit Optional fitting kit 3/4 in. NPT 1/2 in. NPT 1 Customer supplied pipe Customer supplied coupling Hand tighten only! Standard fitting kit Optional fitting kit O-ring Sealant Sealant Optional submersion fitting kit #3-2820.39