射频工程师测试题.pdfVIP

RF Quiz #1 1. What is the impedance of free space? 377ou 2. What happens to the noise figure of a receiver when a 10 dB attenuator is added at the input? a) Noise figure increases by 10 dB b) Noise figure decreases by 10 dB c) Noise figure doesnt change 3. An RF system has a linear throughput gain of +10 dB and an output 3rd -order intercept point (OIP3) of +30 dBm. What is the input 3rd-order intercept point ( P3)? a) +20 dBm b) +40 dBm c) +30 dBm 4. Which filter type has the greatest selectivity for a given order (i.e., N=5)? a) Bessel b) Chebychev (ripple=0.1 dB) c) Butterworth 5. Which mixer spurious product is a 5th-order product? a) 1*LO + 5*RF b) 6*LO - 1*RF c) 3*LO - 2*IF 6. A 2.8 GHz oscillator is phase-locked to a 10 MHz reference oscillator that has a single-sided phase noise of -100 dBc at 1 kHz offset. What is the single-sided phase noise of the 2.8 GHz oscillator at 1 kHz offset? a) -48.6 dBc b) -100 dBc c) -51.1 dBc 7. What is the power of a 2 Vpk-pk sine wave across a 50 ohm load? a) -20.0 dBm b) +10.0 dBm c) +19.0 dBm 8. Which 2-port S-parameter is commonly referred to as reverse isolation in an amplifier? a) S21 b) S22 c) S12 9. What are the minimum and maximum combined VSWR limits at an interface characte rized by a 1.25:1 VSWR and a 2.00:1 VSWR? a) 1.75:1 (min), 2.25:1 (max) b) 1.60:1 (min), 2.50:1 (max) c) 0.75:1 (min), 3.25:1 (max) 10. An ideal directional coupler has a directivity of 25 dB and an isolation of 40 dB. What is its coupling value? I=D+C a) 65 dB b) 40 dB c) 15 dB RF Quiz #2 1. On a Smith chart, what does a point in the bottom half of the chart represent? a) An inductive impedance b) A capacitive impedance c) Power saturation 2. While were on the subject of Smith charts, what is the impedance of the point at the far left edge of the center horizontal line? a) Infin