Flyback电路中RCD钳位电路设计归纳.pdfVIP

Application Note AN-4147 Design Guidelines for RCD Snubber of Flyback Converters Abstract is derived from a buck-boost converter by replacing filter inductors with coupled inductors, such as gapped core trans- This article presents some design guidelines for the RCD formers. When the main switch turns on, the energy is stored snubber of flyback converters. When the MOSFET turns off, in the transformer as a flux form and is transferred to output a high-voltage spike occurs on the drain pin because of a res- during the main switch off-time. Since the transformer needs onance between the leakage inductor (L lk ) of the main trans- to store energy during the main switch on-time, the core former and the output capacitor (C OSS) of the MOSFET. The should be gapped. Since flyback converters need very few excessive voltage on the drain pin may lead to an avalanche components, it is a very popular topology for low- and breakdown and eventually damage the MOSFET. Therefore, medium-power applications such as battery chargers, adapt- it is necessary to add an additional circuit to clamp the volt- ers, and DVD players. age. Figure 1 shows a flyback converter operating in continuous