11gRAC增加节点操作整理.pdfVIP

以下操作参考 oracle 官方文档，且经过详细测试 前期环境确认，包括主机资源，内存资源等等 用户创建，组创建，创建基于已经搭建好的集群 ssh 互信等等，前期准备工作就不详细叙述 确认资源配置正常（预检） Verify the hardware and operating system installations with the Cluster Verification Utility (CVU). After you configure the hardware and operating systems on the nodes you want to add, you can run the following commands to verify that the nodes you want to add are reachable by other nodes in the cluster. [grid@s2-11g ~]$ cluvfy stage -post hwos -n s1-11g -verbose Performing post-checks for hardware and operating system setup 对于预检的输出内容进行确认 预检报错： Checking shared storage accessibility... WARNING: s1-11g:PRVF-7017 : Package cvuqdisk not installed s1-11g No shared storage found Shared storage check failed on nodes s1-11g 在一节点上安装 cvuqdisk-1.0.9-1.rpm [root@s1-11g rpm]# rpm -ivh cvuqdisk-1.0.9-1.rpm Preparing... ########################################### [100%] 1:cvuqdisk ########################################### [100%] 重新预检，预检通过 1. 开始添加节点 grid ： 1.1 Ensure that you have successfully installed Oracle Clusterware on at least one node in your cluster environment. To perform the following procedure, Grid_home must identify your successfully installed Oracle Clusterware home. 1.2 确认节点信息： cluvfy stage -pre nodeadd -n s1-11g [-fixup [-fixupdir fixup_dir]] [-verbose] 1.3 To extend the Grid Infrastructure home to the node3, navigate to the Grid_home/oui/bin directory on node1 and run the addNode.sh script using the following syntax, where node3 is the name of the node that you are adding and node3-vip is the VIP name for the node: 1.4 添加节点： If you are using Grid Naming Service (GNS), run the following command: $ ./addNode.sh CLUSTER_NEW_NODES={node3} If you are not using GNS, run the following command: $ /oracle/grid/oui/bin/addNode.sh CLUSTER_NEW_NODES={s1-11g} CLUSTER_NEW_VIRTUAL_HOSTNAMES={s1-11g-vip} [grid@s2-11g ~]$ /oracle/grid/oui/bin/addNode.sh CLUSTER_NEW_NODES={s1-11g}