Form-3-固化机使用手册(Form-3D打印机).pdfVIP

Print Wash Cure Form Cure FORM CURE SYSTEM OVERVIEW Form Cure provides the light and heat necessary to post-cure 3D printed parts to their optimal properties. 1 Cover. Double walls insulate the cure chamber and internal surfaces reflect light. 2 Heater. A 100 W heating module can heat the chamber up to 176 °F/80 °C. 3 LEDs. An array of 405 nm LEDs help to post-cure parts. 4 Turntable. The rotating plate ensures balanced post-curing across all exposed surfaces. 5 Display. Shows status, time, temperature, and options for configuring Form Cure. 6 Knob. Turn or push to adjust time and temperature settings and to start, pause, or stop post-curing. 7 Power Supply. Provides power to Form Cure. Specifications: 24 V, 6 A 2 USING FORM CURE 1. Connect Power Supply Connect the power cable to Form Cure and a power source. USB port provided for future updates. 2. Insert Washed and Dried Prints Before post-curing, allow at least 30 minutes for isopropyl alcohol (IPA) to fully evaporate after washing. Check all surfaces; post-curing non- dried parts may affect quality. Once parts are dry, lift the cover, then distribute parts on the round turntable and gently close the cover. 3 USING FORM CURE 3. Set Cure Time and Temperature Turn the knob to navigate the display menu. Press the knob to select a feature or setting. Select the time and temperature, then select “Start.” The LEDs will activate once the heater has reached the target temperature. Once a cure cycle has started, use the display or open the cover to pause. POST-CURE SETTINGS For Standard Resins use default post-cure settings of 60 °C for 30 minutes. Proper post-curing requires light and heat. All materials have unique time and temperature settings for optimal ma