第七章VLAN实现 计算机教学课件.ppt

设置主干功能 trunk [on | off | desirable | auto | nonegotiate] wg_sw_a(config-if)# On = 打开主干功能并与对方协商执行 Off = 关闭主干功能并与对方协商执行 Desirable = 与对方协商执行 如果对方设为on、desirable或auto则打开主干功能 Auto = 只有对方设为on或desirable时才打开主干功能 Non-negotiate =打开主干功能并不再与对方协商执行 设置主干功能 wg_sw_a#conf terminal Enter configuration commands, one per line. End with CNTL/Z wg_sw_a(config)#interface f0/26 wg_sw_a(config-if)#trunk on 首先打开端口的主干功能(端口 A) On = 打开主干功能并与对方协商执行 Off = 关闭主干功能并与对方协商执行 Desirable = 与对方协商执行 如果对方设为on、desirable或auto则打开主干功能 Auto = 只有对方设为on或desirable时才打开主干功能 Non-negotiate =打开主干功能并不再与对方协商执行 trunk [on | off | desirable | auto | nonegotiate] wg_sw_a(config-if)# 确认主干功能 wg_sw_a#show trunk [A | B] 确认主干功能 wg_sw_a#show trunk a DISL state: On, Trunking: On, Encapsulation type: ISL wg_sw_a#show trunk [A | B] 创建一个VLAN vlan vlan# [name vlan-name] wg_sw_a(config)# 创建一个VLAN wg_sw_a#conf terminal Enter configuration commands, one per line. End with CNTL/Z wg_sw_a(config)#vlan 9 name switchlab2 vlan vlan# [name vlan-name] wg_sw_a(config)# 确认一个VLAN wg_sw_a#show vlan [vlan#] Slide 2 of 2 Purpose: Emphasize: Note: In the lab, we will only be configuring static VLAN membership. Slide 1 of 2 Purpose: Emphasize: Slide 2 of 2 Purpose: Emphasize: Port 1 = e0/1, ……. AUI = e0/25, A = fa 0/26, B = fa 0/27 Slide 1 of 2 Purpose: Emphasize: This command displays all instances of spanning-tree that are currently running. If you specify a particular vlan, the system just display the spanning-tree operating parameters for the specified VLAN. Spanning tree is enabled by default on all VLANs. Use the following global configuration command to disable Spanning tree for a VLAN: wg_sw_a(config)#no spantree 2 wg_sw_a#sh span 2 Error: STP is not enabled for VLAN 2 Note: The command syntax on the 2900xl is a little different: “show spanning-tree vlan {vlan number}”. One of the lab procedure requires the students to telnet to the core switches (2900xl) to examine the STP status. Slide 2 of 2 Purpose: Emphasize: Note: