手机充电器外壳注塑模具工艺性设计及引力波的实验探测给我们的启示.docVIP

PAGE 学号： 南湖学院 毕业设计 题目: 充电器外壳注塑模具工艺性设计 作 者 届 别 14届 系 别 专 业 指导老师 职 称 讲师 完成时间 2021年5月 PAGE 29 摘 要 本文是关于 充电器的模具设计，我就整个设计流程去全面的介绍关于该注塑模具的整个设计过程。 在设计过程中，首先对塑件进行工艺性分析，考虑塑件的工艺性是否符合模具的设计要求；然后对模具进行结构进行分析，主要包括塑件的工艺技术要求和生产经济性要求。其中工艺技术的要求是要保证塑件的几何形状、尺寸公差及表面粗糙度，生产经济性的要求是塑件的成本低、效率高、寿命长、维修方便、安全。依次包括分型面的选择、塑件位置、型腔数量和布局的确定、浇注系统，排气机构，成型零件，脱模机构，合模导向机构，温度调节系统，分型机构，模架总体等设计和选择注塑机；最后根据前面的塑件、模具结构分析，通过CAD、PRO/E等绘图软件画出相应的模具工件、零件、装配图、三维图等，然后对其进行分析模具的运行过程，从而得出模具的可行性，进而对这次设计进行总结。 关键词：注塑模具；塑件分析；模具设计；Pro/E；CAD Abstract This article is about the mold design of mobile phone charger, the entire design process, I have the entire design process to a comprehensive introduction about the injection mold. In the design process,manufacturability analysis of plastic parts, first consider the technology of plastic parts is in accordance with the mold design requirements; Then carries on the analysis of mould structure, mainly including the plastic parts processing technology and production efficiency requirements. The technology requirement is to ensure that the geometry and dimension tolerance and surface roughness,and production efficiency requirement is of low cost and high efficiency, long service life, convenient maintenance, safe. in turn, including parting surface selection, location and cavity number and layout, pouring system, exhaust, molding parts, demoulding mechanism, guide mechanism, temperature control system, the classification mechanism, overall design and selection of die set injection molding machine;According to the in front of the plastic parts, die structure analysis，CAD, PRO / E and other drawing software to draw the mold parts, spare parts, assembly drawings, three-dimensional map,then subjected to analysis mold during operation, so as to arrive the feasibility of the mold, and then summarize this