多旅行商问题遗传算法.pdfVIP

function varargout = mtspf_ga(dmat,salesmen,min_tour,pop_size,num_iter,show_prog,show_res) %dmat 任意两城市间的最短路径矩阵通过floyed 算法求得结果。 %salesmen 旅行商个数 %min_tour 每个旅行商最少访问的城市数 %pop_size 种群个体数 %num_iter 迭代的代数 %show_prog,show_res 显示的参数设定 nargs = 7; %处理输入参数，用来给定一些默认的参数； for k = nargin:nargs-1 switch k case 0 dmat = 10*rand(20,20); case 1 salesmen = 5; case 2 min_tour = 2; case 3 pop_size = 80; case 4 num_iter = 5e3; case 5 show_prog = 1; case 6 show_res = 1; otherwise end end % 检查输入 矩阵 [nr,nc] = size(dmat); if nr ~= nc error(Invalid XY or DMAT inputs!) end n = nr - 1; % 除去起始的城市后剩余的城市的数 % 输入参数的检查 salesmen = max(1,min(n,round(real(salesmen(1))))); min_tour = max(1,min(floor(n/salesmen),round(real(min_tour(1))))); pop_size = max(8,8*ceil(pop_size(1)/8)); num_iter = max(1,round(real(num_iter(1)))); show_prog = logical(show_prog(1)); show_res = logical(show_res(1)); % 初始化路线、断点的选择 num_brks = salesmen-1; dof = n - min_tour*salesmen; % 可以自由访问的城市数 addto = ones(1,dof+1); for k = 2:num_brks addto = cumsum(addto); end cum_prob = cumsum(addto)/sum(addto); % 初始化种群 pop_rte = zeros(pop_size,n); % 路径集合的种群 pop_brk = zeros(pop_size,num_brks); % 断点集合的种群 for k = 1:pop_size pop_rte(k,:) = randperm(n)+1; pop_brk(k,:) = randbreaks(); end % 选择绘图时的个商人的颜色 可删去； clr = [1 0 0; 0 0 1; 0.67 0 1; 0 1 0; 1 0.5 0]; if salesmen 5 clr = hsv(salesmen); end % 开始运行遗传算法过程 global_min = Inf; %初始化最短路径 total_dist = zeros(1,pop_size); dist_history = zeros(1,num_iter); tmp_pop_rte = zeros(8,n); % 当前的路径设置 tmp_pop_brk = zeros(8,num_brks); % 当前的断点设置 new_pop_rte = zeros(pop_size,n); % 更新的路径设置 new_pop_brk = zeros(pop_