英培训4分析和总结.docxVIP

TRANSLATING NAME: REMARK: RESIST TYPE COLOR: LPI(COLOR-BLUE);NOTATIONS REQ:2 SIDES-TOP BOT(COLOR-WHITE);PUT CHOP ET OR T WITH BLACK INK TO EACH PCB. 阻焊类型和颜色：液态感光兰色，字符要求：顶底层 2 面白色，在每个板上用黑油印上 T 印或 ET THE CONTAMINATION OF THE FINISHED BOARDS MUST BE LESS THAN THE EQUIVALENT OF 1 MICROGRAM SODIUM CHLORIDE PER SQUARE CENTIMETRE, A CLEANLINESS REPORT (PRINTOUT FROM THE CONTAMINATION TEST MUST BE AVAILABLE ON DEMAND) 完成板的离子清洁度必须氯化钠含量小于等于每平方厘米 1 毫克，并提供清洁度报告 DIA. 5 MM SHALL BE TENTED NON PLATED(TNP) 直径 5MM 的 NPTH 孔做盖油（掩孔） -VIA LOCATED INSIDE A SOLDERABLE PAD MUST BE PLUGGED WITH CONDUCTIVE MATERIAL SIMILAR TO FINISH TYPE, OR PLUGGED WITH CONDUCTIVE MATERIAL AND COVERED WITH FINISH. 位于开窗盘中的微过孔要用与板完成类型一致的导电材料塞孔，或用导电材料塞孔并用完成工艺方式覆盖 TH VIA WILL BE PLUGGED WITH SOLDER MASK FROM CS ONLY, TH VIA ON AREA WITHOUT SOLDERMASK DONT NEED TO BE PLUGGED 过孔顶层阻焊塞孔，孔内不上油的孔不塞孔 PACKAGING: BLANK PCB WILL BE PACKED IN A SEALED VACUUM BAG MAX 5 PCBS IN ONE PACK 空白板要密封真空包装，最多 5 板一包 A PAPER SEPARATOR WILL BE USED BETWEEN PCBS 两板间用白纸隔开 EACH PACK WILL CONTAIN SILICA GEL AND HUMIDITY TESTER 每包必须包含硅胶和湿度测试 FINAL PACK MUST PROVIDE FULL PROTECTION DURING TRANSPORTATION 最后的包装要在运输过程中提供全保护 DOCUMENTATION AND METRICS: EACH SUPPLIED BATCH WILL INCLUDE AS MINIMUM THE FOLLOWING DOCUMENTATION AND INFORMATION COC 完工合格证书 ELECTRICAL TEST RESULTS 电测报告 RELIABILITY AND QUALITY TEST REPORT 可依赖性和质检报告 BATCH YIELD INFORMATION FOR ISO 9001:2000 METRICS 符合ISO 9001:2000的批量信息 SHIPMENT DOCUMENTATION 运输通关文件 DIFF SURFACE COPLANAR WAVEGUIDE MODEL OR SURFACE COPLANAR WAVEGUIDE 1B MODEL 差分阻抗做共地面模式 PCB BENT IS 1.5 MAX (0.5% OF PCB LENGTH) 板曲最大 1.5 即板长的 0.5% LEAD FREE MARK IS REQUIRED 加无铅标记