NEC数字放映机二代机错误代码说明.pdfVIP

NEC 数字放映机代机错误代码说明 In regard to MMS Fail, there are three types of errors as shown below. The respective methods of taking measures are described below. 1) FPGA*** This is a configuration error of FPGA. If the associated FPGA is of an input board, try to remount the board or check the flexible cable connections or reinstall the FPGA data. In the case of the other FPGA errors, also try to reinstall the FPGA data. If this check is difficult to carry out, replace the associated board as a whole. 2) Default Data The data involved some deficiency at the time of shipment from the factory. Reinstall the data. 3) User Data This error is caused by a certain deficiency in the user data. As required, copy the user data in the PC so that checks can be made to see the elimination of the problem in the state that the default signal data are used after the execution of factory default. Since part of or all of the previously copied user data have been broken, reuse of these data is not recommendable. If the data are used for the purpose of setup data checks, they should be cleared later. 133MM Reset (Command:Param1)Executed to reset Built-in MMS Param1: When executed to reset Built-in MMS. 001: Executed to reset Built-in MMS when no communications between projector main system and MMS. T-001: Executed to reset Built-in MMS when no communication between external projector and MMS. 1. This message shows the projector reset the MM3000B because of no responses. If MMS Comm Fail occurs, see the MM3000B service manual. 140DLP CommR Fail(Param1Param2Param3:Param4)Communication failure with the ICP board. (Communication I/F is RS-232C) Param1: First portion of ICP command. Param2: Second portion of ICP command. Param3: Third portion of ICP command. Param4: Error type (“Con”, “Tx”, Rxn”, “Nack”, “Tout”) e.g.) DLP CommR Fail(010203:Nak=0001H) ICP returns “NAK” response to the command, “01, 02, 03, …”. 1. If ICP is being updated by ICP Enigma Control Progr