风电项目分析和总结.docx

2.1foundation In order to inspect the electric fittings in the foundation remove a metal plate from the ground platform and go down into the foundation. 地基 要检查地基的电气配件，移开地面平台的一块铁板，就可进入地基内部。 water entry inspect the foundation for traces of water entry in case of stagnant water ,this must be removed immediately. Renewed water entry must be prevented by re-sealing the joint between the lower tower segment and the foundation ring from the outside. 渗水 如发现积水，应检查渗水痕迹并即刻处理。为了避免再渗水，必须对底层塔区与底圈外部之间的接合处重新进行密封处理。 lines,cables,and cable connections visually inspect all lines,cables,and cable connections in the foundation for damage and corrosion. Missing wear or edge protection must be refitted, if required, or correctly positioned. 电线、电缆及电缆连接器 以肉眼检查所有的电线、电缆及电缆连接器是否有破损与腐蚀。遗失的仪器或边角保护，如有需要必须重新装上或正确地放置。 Potential equalization Inspect the terminals of the ground cable for tight fit. Visually inspect the potential equalization rail for corrosion .If the rail is damaged severely, it must be replaced. 2.1.3 电位均衡 检查接地电缆的终端头确保紧密配合。肉眼检查电位钢轨是否被腐蚀。如果钢轨损坏严重，必须更换。 Tower bottom/tower body 塔底/塔体 Lines,cables,and cable connections Visually inspect all lines, cables, and cable connections in the foundation for damage and corrosion .Missing wear or edge protection must be refitte,if required, or correctly positioned. The cables in the tower body must be tightened and must not sag. 电线、电缆及电缆连接器 以肉眼检查所有的电线、电缆及电缆连接器是否有破损与腐蚀。遗失的仪器或边角保护，如有需要必须重新装上或正确地放置。塔体的电缆必须紧固，不可松弛下陷。 Cable support Inspect the tight assembly of the cable support and the tight fit of the cables in the supports. 电缆托架 检查确保电缆托架组件的紧固，以及托架上电缆的紧固配合。 Sockets Check the shockproof and the CEE sockets for function, using a gauge. 插座 使用测量仪器检查抗电击及 CEE 插座的有效性。 Tower lighting/emergency lighting Check the tower lighting for function by switching it on. Replace defect luminaries. Check the function of the emergency lighting in the tower and the nacelle by simulating a power failure, e.g.by activating the fuses in the tower bottom. The emergency lightin