风电控制系统介绍.docx

Modules in the PCS 变桨控制系统(PCS)中的管理单元 Power Management Modules PMM 电源管理单元 Two performance classes with 13 kVA and 26 kVA are currently available. 适用于两个不同级别(13kVA和26kVA)的PMM. A PMM provides the following functions in the PCS: PCS中的PMM提供以下功能: DC power (DC link) for the digital axis controllers PMC 数字式轴控制器(PMC)直流电源 Charging and monitoring of the batteries (PBS) 电池(PBS) 充电与监测 Transformation of the power from the batteries into the 560 V DC link following a mains power failure 主电源故障中电池组的电源转换到 560Vdc Battery check and logging of the battery data (BMS) 电池数据的检测和记录(BMS) Monitoring of the mains voltage 主电压监控 Generation of a 24 V DC auxiliary supply for the axis even after a power failure 电源故障中 24Vdc 备用供给 Temperature measurement and control for motors, controllers and boxes 电机,控制器和箱体的温度测量和控制 Processing of set points 设定点的处理 Controlling data communication with the digital axis controller via the CAN bus 数字式轴控制器通过 CAN BUS 总线进行数据通讯 Data transmission to the higher-ranking host computer via the CAN bus 数据通过 CAN bus 传送到主机. Service interface for setting up and parameterization of the PCS (RS 485) PCS(RS485) 服务端口的设置和参数化 基本介绍和运行原理 Terminals and Plugs 端子排和插头 10 维修接口 RS485 This RS485 interface is designed for half duplex operation. It is isolated from the sy stem electronics and offers high-impedance frame connection of the interface potential. All devices which are connected to this bus must be connected in parallel at pins 1, 2 and 3. For the last device, a jumper is additionally connected from pin 4 to pin 2 to terminate the bus with 120 ohm. Only twisted-pair cables with shield may be used. The shield must be connected at both ends. Conductor size max. 1.5 mm2 RS485 接口用于半双向通讯.它是从系统电子元件中分离出来的并提供接口电位的高阻抗连接 .所有连接在 BUS 总线上的设备需并联在 pins 1,2 和 3 上. 在设备中,一根 120 ohm 跳线从 BUS 总线的pin2 连接到 pin4 端口. 导线长度最大:1.5 mm2. X11 Field bus connection A to system management Field bus 总线连接,A 到系统管理 This CAN bus interface is designed for real-time communication with the system management. The maximum baud rate equ