叉车安全操作.pptxVIP

叉车操作;叉车安全驾驶;(一)日常应做例行检查及保养工作;每日完工后，检查铲车情况 应使您的铲车，保持最良好的健康状态。由于您 的细心保护，不但可以减少高额修理费用。更能 保证您本人的安全，以及您四周的人员和设备。 当有故障时，应立即报告上司。 Check the condition of your forklift truck after the day’s Work Keep your forklift truck in the best of health.Your personal Care will not only prevent costly repairs and reduce downtime but will also make you safer,as well as the people and equipment around you.Report any faulty performance without delay. ; (二)货物安放;确认载货台板上的货物是否有松驰 稳定而安全捆扎好的货物，才能装运。 Watch for loose loads Handle only stable,safety arranged loads. ;　(三)常见之操作错误;经常装借背架和认顶 向高处堆积货物时，要特别注意落下货物，同时更 需确认堆积在顶上的货物，有无松散情况． Always use the load backrest extension and overhead guard for hig stacking． Be especially alert for falling objects when high stacking. Make sure no loose articles are lying on top of the load. ;　(三)常见之操作错误;在任何时候都要完全控制好车辆 按照工作地区四周情况,用安全速度进行运转.严守 各项规则和限制. Keep your forklift truck under control…at all times Always drive at safe speed considering all conditions. Be sure you understand your limtations.; (三)常见之操作错误;转弯时减速及按下喇叭发出警告 在视线不良地区,应减速运转. 如有后视镜等设备,应加利用.注意”停止”标识,一旦停车后,如有必要,按下喇叭,然后,慎重前进. Go slow and sound the horn at corners Go slow wherever vision is limited or obstructed.If your plant has traffic mirrors,use them .Observe stop signs,stop your forklift truck completely, sound the horn if necessary and then proceed with extreme caution.; (三)常见之操作错误;注意后端摆动在狭小通路或场所，应注意车辆后端摆动。铲车是利用后轮爬行之故，在转弯进，后端可能发生大的摆动。Watch rear end swingbecause the rear wheels steer your truck，the rear end swings wide when you trun。Use care in aisles and other tight plces。; （三）常见之操作错误;搭乘人员，亦在禁止之列 铲车不能装卸叉车本来目???以外之货载。由于叉车没有搭乘人员之安全设备，绝对不能容人乘坐。 Don‘t carry passengers Again，don’t use your forklift truck for moving loads for which it was not designed。There is NO safe place on a forklift truck for a passenger to ride。;（三）常见之操作错误;伸叉式电叉车 上斜坡时，铲叉及排架应调至适当后倾角度，行驶时铲叉应向上坡位。 下斜坡时，应倒车行驶，防止货物颠倒滑落。 Reach trucks These trucks are always driven with the forks towards the crown of a hill or slope。This type of truck sho