(3.3.1)--2.3.2组合体的组合形式（二）切割型.pptVIP

2. Projection basis2.3 Assembly 2.3.2 Assembly form of combination (Ⅱ) cutting type Sharing --- the section line is a common line shared by the cut plane and the three-dimensional body surface. Closure --- Since any three-dimensional has a certain range, the section line must be a closed plane figureThe intersection line between the intercepting plane and the three-dimensional surface is called the section lineBasic propertiesCutting type(1) Cutting quadrilateral (2) Quadrilateral slottingCut a rectangular slot above the quadrilateral, try to complete the horizontal projection and side projection of the rectangular slot of the quadrilateralThe wider the slot, the greater the contractionThe lateral projection of the bottom of the slot is not visible (3) Cylindrical groovingThe side projection of the bottom of the groove is not visibleThe wider the slot, the greater the contractionBecause the last two turning lines of the column are cut off at the slotted area, the profile line in the left view is contracted in the slotted area. Drawing order of cut assemblies:On the basis of drawing the original shape of the combination, draw the cut view in order according to the position and shape of the cut part.The following is an example of how to draw a cut combination with the three-dimensional diagram shown in the figure.Drawing steps: Drawing steps: (III) Comprehensive typeMost of the assemblages are both stacked and cut, and are of a comprehensive type