消防自动报警系统.pptVIP

1. Relative humidity is often greater than 95%;Smokeless fire; 2.3 There is a lot of dust;4 Smoke and vapor retention under normal conditions;5 Kitchen, boiler room, generator room, drying workshop, etc.Smoking room, etc.;7 Other halls and public places where smoke detectors should not be installed. * The infrared light and ultraviolet light emitted by the fire detection flame are used to alarm.It is divided into infrared sensor and ultraviolet sensorApplication Place:1. There is strong flame radiation in fire;2 liquid combustion fire and other non-smoldering stage fire;The need for a quick response to the flame; * 1 Flameless fire may occur;2 There is smoke diffusion before the flame appears;3. The lens of the detector is easy to be polluted;4. The line of sight of the detector is easily blocked;5 The detector is susceptible to direct or indirect irradiation by sunlight or other light sources;6. Under normal conditions, there are open flame operations, X rays, arcs and other influences. * It can detect 2 or more fire parameters when a fire occurs, divided into 2 compound detector or 3 compound detector.According to the fire detection characteristics, it can be divided into smoke and temperature sensing type, temperature sensitive type, smoke sensitive type and infrared light beam smoke sensing type.The composite detector not only makes the performance more reliable, but also expands the application range of the detector and can be used in some special places. * 1. The horizontal distance between the detector and the wall and beam edge should not be less than 0.5m;2. There should be no occlusion within 0.5m around the detector;3. The horizontal distance between the detector and the air supply outlet of the air conditioner should not be less than 1.5m; The horizontal distance to the orifice of the porous air supply ceiling should not be less than 0.5m;4. When the detector is set on the ceiling of the inner walkway with a width less than 3m, it should be arranged in t