二零二三年 优质公开课Feederanditsclassification.pptxVIP

Design and budget of mobile communication engineeringFeeder and its classificationCourse team: Xiaoji Zhao Xuelian Fang Yueqiu Dong Liu Yang SHENZHEN POLYTECHNIC Contents 1Classification of feeder 2Parameter of feeder 3Feeder model selection Classification：according to wire diameter；1/2”7/8”5/4”13/8”1. Classification of feeder Feeder attenuation：It mainly includes resistance loss of conductor and dielectric loss of insulation material。The magnitude of the loss is expressed by the attenuation coefficient，dB／m or dB/100m；Influence factor：The larger the feeder size, the smaller the attenuationThe attenuation increases with the increase of feeder lengthThe attenuation increases with the increase of working frequencyIt is necessary shorten the length of feeder as far as possible, and choose suitable size feeder 。2. Parameter of feeder Characteristic impedance : The ratio of voltage to current at infinitely long transmission lines ； Ｚ0?=?50?Ω?，Ｚ0?=?75?Ω? Influence factor: conductor diameter ——D dielectric constant ——εrthe characteristic impedance of the feeder is matched with that of the antenna 。2. Parameter of feeder 2. Parameter of feedermodel 1/41/2ultra soft1/27/8applicationShunt routing for wiring difficultiesShunt routing ，The length is less than 100m Shunt routing ，less useLong distance trunk routingSize(mm)outer diameter of inner conductor2.4±0.13.6±0.14.8±0.19±0.1outer diameter of outer conductor7.5±0.112.2±0.113.7±0.125±0.2Outer diameter of insulating sleeve9.7±0.113.5±0.116±0.128±0.2characteristic impedance（Ω）50±150±150±150±1upper limit of working frequency(GHz)＞4＞4＞4＞4Minimum bending radius(mm)＜50 ＜30 ＜100 ＜150 Attenuation(dB/100m)900MHz＜14＜11＜7＜41800MHz＜21＜16＜11＜6working temperature-40~85℃inflaming retarding functionYYYYAttenuation coefficientCharacteristic impedanceUpper limit of working frequencySizeWeight 900M feeder model selectionMod