交通灯控制系统设计.docxVIP

四川师范大学成都学院现代通信原理课程设计 交通灯控制系统设计 学生姓名 学 号所 在 系专业名称班 级指导教师 XXX XXXXXXXXX XXXXXXXXXX XXXXXXXX XXXXXXXXXXXX XXXXXXXXX 四川师范大学成都学院二○一二年六月 Ⅲ 四川师范大学成都学院现代通信原理课程设计 四川师范大学成都学院现代通信原理课程设计 PAGE 1 PAGE 1 交通灯控制系统设计 学生：XXX 指导教师：XXX 内容摘要：因为社会经济的发展，城市交通问题越来越引起人们的关注。人、车、路三者关系的 协调，已成为交通管理部门需要解决的重要问题之一。城市交通控制系统是用于城市交通数据监测、 交通信号灯控制与交通疏导的计算机综合管理系统，它是现代城市交通监控指挥系统中最重要的组 成部分。 实现路口交通灯系统的控制方法很多，可以用标准逻辑器件、可编程序控制器 PLC、单片机等方案来实现。其中用标准逻辑器件来实现电路在很大程度上要受到逻辑器件如门电路等的影响，调 试工作极为不易，而笔者对单片机运用来进行系统的设计开发也不是很熟悉，因此，最终笔者选择 了用可编程的控制器PLC 来实现系统功能的设计，完成本次课设的题目。 关键词：PLC 交通灯 程序 报告 设计 Traffic light control system design Abstract：Along with the development of the society economy, the city transportation problem causes peoples concern more and more. The coordination of the person ,car , the road threes relation, have become one of the important problems that the transportation management section demand resolve. The city transportation control system is the calculator that used for the city transportation data monitor. The transportation signal beacon control and transportation to appease comprehensive management system, it is in the modern city transportation supervision conductor system to constitute part most importantly. Carry out the control method of the street corner transportation light system a lot of, can carry out with the standard logic spare part. Programmable preface controller PLC, single slice machine etc. Carries out the influence that the electric circuit wants to be subjected to the logic spare part, such as door, electric circuit to a large extent etc. with the standard logic spare part among them, adjust to try a work extremely not easy, and writer to single slice the luck use is not very either to acquaint with to the design development of carry on the system, therefore, the end writer chooses to use programmable controller PLC to carry out the design of the system function, completion originally time the lesson establish of topic. Keywords: The PLC transportation light procedure report des