GBT 257392010 核电厂阀门调试技术导则.docxVIP

ICS 27.120.99 F 69 National Standard of the People’s Republic of China GB/T 25739—2010 Technical Guideline of Valves Commissioning for Nuclear Power Plant Issued on December 23, 2010 Implemented on May 1, 2011 Issued by General Administration of Quality Supervision, Inspection and Quarantine of the Peoples Republic of China and Standardization Administration of the Peoples Republic of China  GB/T 25739-2010 PAGE 13 GB/T 25739-2010 PAGE 2 Technical Guideline of Valves Commissioning for Nuclear Power Plant Scope This Standard stipulates the commissioning method, test requirements and acceptance criteria for the safety and non-safety electric isolation valves, pneumatic isolation valves, electric regulating valves, pneumatic regulating valves and manual isolation valves of the nuclear power plant. This Standard applies to the onsite commissioning of the valves of nuclear power plant. Terms and definitions The following terms and definitions are applicable in this document. Actuator A driving device which operates the valve and connects the valve body; this device can adopt electric, pneumatic or combined mechanism. Its movement can be controlled via stroke, torque, thrust or their combinations. Valve remote controls A mechanical force transfer mechanism that transfers the force of the valve actuator or hand wheel to the remote valve stem to open or close the valve (also called valve remote transfer mechanism). No-load test The action test of the valve when there is no medium. Load test The action test of the valve under the medium pressure and system running conditions; Commissioning Commissioning of electric isolation valve Commissioning preconditions The commissioning personnel shall have received the electric isolation valve commissioning skill training and have the corresponding qualifications and authorizations. The instruments and meters used for the commissioning shall pass the relevant inspections and tests and are still in their servi