铜合金弹性带材平面弯曲疲劳试验方法（英文版）.pdfVIP

铜合金弹性带材平面弯曲 Methodsforplanebendingfatigueofcopperalloy elastic strip 1 Scope This document specifies the normative reference documents, terms and definitions, principles, test conditions, test machine, test samples, test steps, results presentation and test reports of copper alloy elastic strip. This document isapplicable to the test for the plane bending fatigue performance of copper alloy elastic materials with thickness of 0.1 mm～1.0mm at 10℃～35℃. 2 Normative references The following referenced documents are indispensablefor the application of this document. For dated references, only the edition cited applies. For the undated references, the latest edition of the referenced document(including any amendments)applies. GB/T 16825.1-2022，Metallic materials—Calibrationand verificationof static uniaxial testing machines—Part1:Tension/compression testing machines—Calibrationand verificationof the force-measuring system 3 Terms and definitions There are no terms and definitions to be defined inthis document. 4 Principle Installthe prepared sample on the constant flexible fatigue tester with fixed cantilever, andapplya loadon it,Bendingrepeatedlyatacertainfrequencyuntilthespecimenfailsornumber of tests reaches the specified value of cycles.See Figure 1 for the schematic diagram. 2 Notes: 1 - Fastening bolt； 2 - Fixed clamp block； 3 - Loading device； 4 - Sample; L - The distance of the point of application to the point of force, in millimeters （mm）. Figure 1— Schematic diagram of the principle 5 Test conditions 5.1 Test environment temperature is 10℃ ~ 35℃. 6 Testing machine Varioustypesoffixed cantileverconstant flexiblefatiguetesterwithfixed cantilever can be used, but all should meet the following requirements: 6.1 Testing machine should have automatic counting device; 6.2 The loading system of the t