水泥混凝土路面抗折强度检测方法研究.pdfVIP

试验研究 Experimental Research 水泥混凝土路面抗折强度检测方法研究 1 1 1 1 1 2 吴丹丹 　罗　楠 　闵宗军 　李薇薇 　张建勇 　杨　杰 1. 北京市建筑工程研究院有限责任公司 北京 100039 2. 北京住总新型建材有限公司 北京 101304 摘 要：研究了水泥混凝土路面抗折强度的检测方法，通过对模拟水泥混凝土路面中钻取的芯样试件进行抗 压、劈裂抗拉及抗折试验，获得芯样抗压、劈裂抗拉强度和水泥混凝土抗折强度。以芯样抗压、劈裂抗拉强度为 自变量，水泥混凝土抗折强度为因变量，采用最小二乘法对试验数据进行回归拟合，给出相应的芯样抗压、劈裂 抗拉强度推定水泥混凝路面抗折强度换算曲线（即测强曲线）；同时从不同角度比较了2种方法的检测精度。结果 表明：芯样抗压与水泥混凝土抗折强度存在显著的相关性，相关系数为0.92，平均相对误差为12.7%，相对标准差 为12.9%，建立的幂函数芯样抗压法测强曲线具有足够的工程检测精度，研究结果可为工程质量检测与控制提供 参考价值。 关键词：混凝土；抗折强度；检测方法；测强曲线 Research on Testing Method of Flexural Tensile Strength of Cement Concrete Pavement Abstract: In this paper, the testing method of flexural strength of cement concrete pavement is studied, and the tests of compressive strength, splitting tensile strength and flexural strength of core samples drilled from simulated cement concrete pavement are carried out, the compressive strength and splitting tensile strength of core sample and flexural strength of cement concrete are obtained. The compressive strength and splitting tensile strength of core sample are independent variables, and the flexural strength of cement concrete is dependent variable, the experimental data were regressed with least squares, and the conversion curves (i.e. the strength-measuring curves) for predicting the flexural strength of cement concrete pavements were given for the compressive and splitting tensile strength of the corresponding core samples, at the same time, this paper compares the detection accuracy of the two methods from different angles. The results show that there is a significant correlation between compressive strength of core sample and flexural strength of cement concrete, the correlation coefficient is 0.92, the average relative error is 12.7%, the relative standard deviation is 12.9%, the establishe