90度塑料弯管成型模具设计说明书.docVIP

本科学生毕业设计 90度塑料弯管成型 工艺及模具设计 PAGE II PAGE II 黑龙江工程学院本科生毕业设计 PAGE I PAGE I 摘 要 90°塑料弯管是日常生活中比较常见的零件，使用量也比较大。它所使用的材料为无规共聚聚丙烯简称PP-R，以其优异的耐冲击、耐腐蚀和耐高温性能，良好的耐压、保温和耐老化性能以及卫生无毒，安装方便，外观美观等特点，广泛的应用在了住宅生活、农业的供排水、供气、排气用管、电线导管、灌溉、工矿业、雨水管、工业防腐管等方面。本次设计采用斜导柱分型抽芯机构进行分型，型腔布置采用一模两腔的形式，浇口为侧浇口，在模具内有冷却系统。通过制定合理的成型工艺过程和模具结构方案完成模具设计，完成工程图和设计通过计算能够的出说明书。并对模具的各项数据进行校对以及审核，保证模具能够正常使用。并经过Moldflow软件进行流动性经过分析的出，进一步完善设计。 关键词：塑料模具；模具设计；90°塑料弯头；模流分析；螺纹嵌件。 ABSTRACT The 90 degree plastic elbow is a relatively common part in daily life，and its consumption is relatively large. The materials used are random copolymerized polypropylene (PP-R) for short，with its excellent impact resistance，good pressure， corrosion resistance and high temperature resistanc，heat preservation and aging resistance， health non-toxic， convenient installation， beautiful appearance and so on. It is widely used in water supply and drainage，irrigation and supply for residential life，industry and agriculture and agriculture. Gas，exhaust pipe，wire conduit，rainwater pipe，industrial anticorrosive pipe and so on. This design uses angle pin core pulling mechanism for type cavity layout in the form of the first mock exam two chamber，gate is the side gate，a cooling system in the mould. Through the formulation of reasonable molding process and die structure plan， the mold design is completed， and the engineering drawings and design calculation instructions are completed. And check all the data of the mold to ensure that the mold can be used normally. And through Moldflow software for liquidity analysis， further improve the design. Through this design，I have deepened my understanding of injection mold. Key words: Injection Mould； Mold Design； 90 Degree Plastic Elbow； Mold Flow Analysis， Thread Nsert. 目 录 摘要 I TOC \o 1-3 \f \h \z \u 18124 Abstract II 28253 第1章 绪 论 1 27646 1.1 选题背景及意义 1 16140 1.2塑料模具的发展状况 1 10049 1.2.1国内模具发展现状 1 15087 1.2.2?国外模具发展现状? 1 2483 1.2.3模具的发展趋势 2 29680 第2章 塑件的分析 3 5575 2.1 产品分析