(9704)--预制混凝土夹心墙板热工性能模拟与计算分析.pdfVIP

预制混凝土夹心墙板热工性能模拟与计算分析 摘 要： 采用有限元软件ABAQUS 对4 块采用不同连接件的预制混凝土夹心墙板的热工性能进行模拟，并将模拟值与试验值 进行对比分析；同时，对拉接件的热桥效应进行理论计算并分析。结果表明：与无连接件的预制墙板相比，采用纤维连接件的墙板 的传热系数提高8%，而采用金属连接件的墙板分别提高20.9%与14.3%；由于软件模拟与真实试验条件存在一定偏差，导致二者 的结果存在一定程度的误差；修正的区域法可较准确的计算墙板的热阻，可为计算墙板的热阻值提供依据。 关键词： 混凝土夹心墙板；热工性能；拉结件；热桥效应 中图分类号： TU528.72 文献标志码： A 文章编号： 1002-3550 （2020）03-0128-04 ZHU Wenxiang ，XU Jinfeng ，WU Zhimin ，ZHANG Haixia，HAN Wei ，CAI Min （Jiangsu Province Key Laboratory of Research of Green Building and Structural Safety ，Jiangsu Jianke Technique of Energy-conservation for Buildings Co.，Ltd. ，Jiangsu Research Institute of Building Science Co. ，Ltd. ，Nanjing 210008 ，China） Abstract:The finite element software ABAQUS was used to simulate the thermal performance of four precast concrete sandwich wall panels with different joints ，and the simulated values were compared with the experimental values.At the same time，the thermal bridge effect of the shear connectors were calculated and analyzed.Results showed that the thermal bridge effect caused by shear connectors was obviously. Compared with the wall panel without connectors，the heat transfer coefficient of the wall panel with fiber connectors was increased by 8% ， while wall panels with different metal connectors were increased by 20.9% and 14.3% ，respectively.Certain error were existence between test and simulation results because of the deviations between simulation and real test condition.Revised zone method calculates the thermal resistance of sandwich wall panels accurately，and it can be used as basis for calculation of the thermal resistance value. Keywords:prefabricated concrete sandwich wall panels ；thermal performance ；connector ；thermal bridge effect 本研究采用有限元软件对采用不同拉结件的混凝土 0 引言 夹心保温