amc直流伺服产品手册be25a20ac.pdfVIP

  • 0
  • 0
  • 约3.79万字
  • 约 12页
  • 2023-10-09 发布于北京
  • 举报
Description Power Range Peak Current 25 A The BE25A20AC servo drive is designed to drive brushless DC motors at a high switching frequency. A Continuous Current 12.5 A single red/green LED indicates operating status. The drive is fully protected over-voltage, under Supply Voltage 30 - 125 VAC voltage, over-current, over-heating and short-circuits across motor, ground and power leads. Furthermore, the drive can interface with digital controllers or be used stand-alone and requires only a single unregulated AC power supply. Loop gain, current limit, input gain and offset can be adjusted using 14-turn potentiometers. The offset adjusting potentiometer can also be used as an on-board input signal for testing purposes. This drive can use quadrature encoder inputs for velocity control. See Part Numbering Information on last page of datasheet for additional ordering options. The hardware installation for the og drive family is available for download at . Features  Four Quadrant Regenerative Operation  Adjustable Input Gain  DIP Switch Selectable Modes  Selectable 120/60 Hall Commutation Phasing  Adjustable Current Limits  Encoder Velocity Mode  Differential Input Command  Drive Status LED  Built in Shunt Regulator Circuit  Velocity Monitor Outputs  On-Board Test Poten

文档评论(0)

1亿VIP精品文档

相关文档