教程dm chsketch ws3工作坊3 3静态混合器设计建模师目标本研讨会将引导您完成在.pdfVIP

Goals • This workshop will take you through the process of creating a geometry in DesignModeler and using the Automatic meshing method to create a simple mesh for that geometry. • The basic steps involved reating a CFD mesh are: – 1. Create the Geometry (DesignModeler). – 2. Define Named Selections for some 2D regions (DesignModeler). – 3. Create surface and volume mesh (Meshing). • This workshop is intended to give you a feel for the geometry and mesh creation process from start to finish. Some of the methods used and the steps you follow will be discussed and ex ined in later lectures. Goals… • The geometry you will be creating and meshing is shown below: Launch DesignModeler 1. Launch ANSYS Workbench • Start Programs ANSYS 12.0 ANSYS Workbench 2. Launch DesignModeler and start new geometry • Double Click “Mesh” under “Component Systems” • Right click on the Geometry box in the Project Schematic and click on “New Geometry…” • Select Meter for length unit, then click OK Create Geometry You will begin by creating a sketch of the main body profile which you will revolve about the Y-axis to create the main body of the mixer 3. Modeling: ZX ne – Selecting ZX ne on the tree dis ys the sketch ne on the Model View. 4. Click on the Look-At icon to orient the view normal to the ne. 5. Modeling: Sketching tab – Selecting the Sketching tab after selecting a ne creates a new sketch and toggles to Sketching mode 6. Sketching: Settings Grid – This is a simple geometry characterized by dimensions of 2.0 m, 1.0 m, 0.5