GM6102M-螺栓和螺钉的表面缺陷-chs.pdfVIP

SurfaceDiscontinuitiesonBoltsandScrewsGM6102M

螺栓和螺钉的表面缺陷共16页第1页

2004年4月版本通用

1Scope

Thisstandarddefines,illustratesandspecifiesallowablelimitsforthevarioustypesofsurface

discontinuitiesthatmayoccurduringthemanufactureandprocessingofbolts,screws,andstuds,including

heattreatedmachinescrews,tappingscrews,andscrewandwasherassemblies(thewashercomponentsof

assembliesareexcluded).Thisspecificationcoversfastenersinsizes5to24mm(No.12to1inch),

inclusive,withlengthsupto150mm,inclusive,andwithspecifiedminimumtensilestrengthof830Mpa

(120000psi)andgreater,whichareprimarilyintendedforuseinautomotiveassemblies.

1．范围

本标准定义、说明和规定了不同类型表面缺陷的允许限度。螺栓、螺钉和螺柱（包括热处理机械螺

钉，自攻钉和螺钉与垫圈组合件，不包括垫圈零部件）在制造和加工过程中产生表面的外观缺陷。

标准所涉及的零件适用于5--24mm(No.12--1inch)，长度小于等于150mm，规定最小的抗拉强度

大于等于830Mpa(120000psi)，装配在汽车上的零件。

1.1Remarks.Thisstandarddoesnotincludeinspectionsamplingrequirements.Itisintendedthatthe

purchasershallspecify,intheoriginalinquiryandpurchaseorder,theinspectionsamplingrequirements

whichtheproducermustsatisfytodemonstratetheacceptabilityofboltsandscrewswithrespecttosurface

discontinuities。

1.1备注。本标准不包括检测样品要求。采购方应在调查表和采购定单正本中规定检测样品要求，生

产产家必须证明螺栓与螺钉表面缺陷的接收限度。

2References

Note:Onlythelatestapprovedstandardsareapplicableunlessotherwisespecified.

2.1ExternalStandards/Specifications.

ASTME3

2.2GMStandards/Specifications.

GMW3001GMW3059

2．参考。

备注：除非另有规定，仅采用最近批准的标准。

2.1外部标准/规范。

GMW3001GMW3059

3Requirements

3.1TypesofSurfaceDiscontinuities.Forthepurposeofthisstandard,surfacediscontinuitiesonbolts

andscrewsareclassifiedinto