UMCo50合金的同质及T800堆焊层组织及性能.pdfVIP

HotWorkingTechnology2020,Vol.49,No.9

UMC〇50合金的同质及T800堆焊层组织及性能

薛海涛^唐强2,颜超2,贾俊亚\郭卫兵^陆志明2

(1.河北工业大学材料科学与工程学院，天津300400;2.中国航天科技集团公司北京航天动力研究所，北京

100076)

摘要：采用钨极氩弧焊和等离子弧粉末堆焊在UMC〇50母材上分别堆焊UMC〇50焊丝和T800钻基合金粉末，

利用X射线衍射仪、扫描电镜、显微硬度计、高温摩擦磨损试验机对UMC〇50与T800堆焊层的组织、硬度、高温耐磨

性、耐热腐蚀性能进行了对比研究。试验结果表明，UMC〇50堆焊层由a-Co和e-Co相组成,T800堆焊层由ot-Co和

e-Co和Laves相组成。与UMC〇50堆焊层相比，Laves相的存在明显提高了T800堆焊层的硬度和高温耐磨性，由于

T800堆焊层Cr元素含量较低，耐热腐蚀性能低于UMC〇50堆焊层。

关键词：UMC〇50;T800;高温耐磨性；耐热腐蚀性

DOI:10.14158/j.cnki.1001-3814.

中图分类号：TG455文献标识码：A文章编号：1001-3814(2020)09-0036-05

MicrostructureandPropertiesofHomogeneityandT800SurfacingLayers

ofUMC〇50Alloy

XUEHaitao1,TANGQiang2,YANChao2,JIAJunya1,GUWeibing1,LUZhiming2

(1.SchoolofMaterialsScienceandEngineering,HebeiUniversityofTechnology,Tianjin300400,China;2.Beijing

AerospacePropulsionInstitute,ChinaAerospaceScienceandTechnologyCorporation,Beijing100076,China)

AbstractTungstenargonarc：weldingandplasmaarcpowdersurfacingwereusedtooverlayUMC〇50wireandT800

cobalt-basedalloypowderonUMC〇50basemetalrespectively.Themicrostructure,hardness,hightemperaturewear

resistanceandthermalcorrosionresistanceofUMC〇50andT800surfacinglayerswerestudiedbyX-raydiffraction,scanning

electronmicroscopy,microhardnesstesterandhightemperaturefrictionweartestingmachine.Theresultsshowthatthe

microstructureofUMC〇50surfacinglayeriscomposedofa-Coande-Co,whiletheT800surfacinglayeriscomposedof

a-Co,e-CoandLavesphase.ComparedwithUMC〇50surfacinglayer,theLave