73611SS82A手机装配作业指导书.ppt

Working Instruction Step-Tech Internal used Only Title SS820A Assembly Working Instruction DOC # 73-60-011-00 Date Jul-28-04 Revision 1.0 Page# * of 20 Amendment History Signature S/N Rev. Description of Change Originator Check Approval DCR. 01 1.0 Initial Wanglin Chenshaofeng John Li Originator: Lin Wang Signature: Checked by: Shaofeng Chen Signature: Approval: John Li Signature: 目录 目的 范围 3. 基本外形定义 4. 工厂组装概览 5. 工厂组装具体步骤 目的 本文件详细描述了SS820A产品在工厂组装时的工艺流程及操作指导。 范围 本文件只适用于SS820A产品。 3. 基本外形定义 Main Lens Side Key Key Pad Assy. Slide Assy. Battery Assy. Base Camera Lens Rear Housing 4. 工厂组装概览 (2)Front Slide (3) Receiver ⑴Assy ,Lens ⑴Rear Slide ⑵ Gasket 裸机 ⑶ Assy Base (4) Assy Battery ⑴ Assy Slide ⑵ Spring*2 (1) Assy Front Slide (2) Assy Key Pad Slide (3) Metal Dome Slide (4) Assy, Slide PCBA (5) Assy Rear Slide (6) Screw Slide*4 (7) Screw Cover Slide ⑴ Antenna (2) Microphone (3) Rear Housing (4) Side key ⑴ Assy Front Housing (4) Main PCBA (5) Assy Rear Housing (6) Screws Base*4 (2) Key Pad, Digit (3) Metal Dome,Digit (2) Motor ⑴Slide PCBA (3) Speaker (4) LCM Front Housing Main PCBA Sidekey Assy Battery Screw cover Rear Slide Key Pad, Digit Key Pad, Slide Rear Housing Microphone Spring, Slide Dome, Slide Dome, Digit Front Slide Camera Sensor Antenna Assy,SlidePCBA Receiver Assy. Lens (1). 取一Assy, Slide PCBA，检查其是否有压痕. 划伤. 破损等 不良； (2). 取一Metal Dome, Slide，撕去要粘贴的一层双面胶保护膜； (3). 通过Bracket 上的3个定位柱进行定位，将Metal Dome, Slide 安装到Slide PCB键盘区上。 注意: A. 该站操作员须戴指套作业； B. Dome安装时须定位准确，防止贴偏、翘起等不良现象。 文字说明 图片说明 5.1 Metal Dome 与 Slide PCBA 组装 元件名称 P/N (料号) 卡具 数量 数量 M211 Metal Dome ,slide 01-10130A000 1 Assy, Slide PCBA 注 ： 为Bracket 上的定位柱 Assy, Slide PCBA Metal Dome,Slide Metal Dome夹具 1 5.2 前滑盖组装 (1). 取一Rece