基于状态组合法的三相电压型PWN逆变器的研究——毕业设计外文翻译、中英文翻译.doc

英文原文： Study of Voltage-Source PWM Inverter Based on State Combination Method Wenyi Zhang, Yuye Wang, Weiming Tong, Huiming Xu, Lemin Yang Abstract--A state combination method is presented for a voltage source PWM inverter. Main circuit states are obtained through the on-off state combination of switch devices, and valid main circuit states are determined according to the characteristic of the voltage-source PWM inverter. The ideal output voltage waveform of the voltage-source PWM inverter is determined by the combination of all kinds of valid main circuit states. The output voltage waveform of a single-phase half-bridge voltage source PWM inverter is analyzed in detail by the state combination method and the corresponding control strategy is obtained, which is extended to the single-phase full-bridge voltage-source PWM inverter and the three-phase bridge-type voltage-source PWM inverter. According to the analysis of deadtime problem, non-dead-time control strategy is presented. The relation between working and output voltage waveform of the main circuit of the voltage-source PWM inverter is analyzed in nature and the control strategy of the output voltage waveform of the voltage-source PWM inverter is improved by the state combination method, which establishes the foundation for the further research of the practice output voltage waveform of the voltage-source PWM inverter. Index Terms--state combination method, voltage-source PWM inverter, output voltage, dead-time I. INTRODUCTION WITH the development of power electronic technology,the inverter has been widely applied in many fields. The inverter is therefore attracting attention of the researchers. An inverter is a contrary transformation device of a rectifier, whose function is to change AC into DC [1]. According to the property of the DC side power supply, the inverter is divided into the voltage-source inverter and the current-source inverter. Currently, the commonly used inverter is almost the voltage-sour