(A003)塑胶成型技术资料.ppt

成型模具 成型模具 成型模具 成型模具 成型模具 成型模具 成型模具 成型模具 成型模具 成型模具 成型模具 成型模具 成形模具 成型模具 成型模具 模溫控制 射出成形模具設計 流道設計 流道設計 流道設計 流道設計 全圓型 優 流道設計 流道設計 流道設計 流道設計 無澆道設計 無澆道設計 澆口設計 澆口設計 澆口設計 澆口設計 澆口設計 澆口設計 澆口設計 澆口設計 澆口設計 澆口設計 成品設計 Basic Geometry Reinforcements Basic Geometry Reinforcements Basic Geometry Reinforcements Basic Geometry Processing Concerns Basic Geometry Wall Thickness Uneven Shrinkage Defects Basic Geometry Wall Thickness Wall Design Basic Geometry Wall Thickness Wall Transitions 模具排氣 模具排氣 模具排氣 離模角度設計 離模角度設計 射出成形問題分析 射出成形問題分析 射出成形問題分析 射出成形問題分析 射出成形問題分析 射出成形問題分析 射出成形問題分析 Flash Loose Clamp Injection Pressure Too High Injection High Pressure on Too Long Injection Speed Too Fast Melt Temperature Too High Improper Feed Rate Damaged or Overheated Mold Short Shots Short Shot is the Inability to Completely Fill a Part. Short Shots Ways to Minimize Short Shots Check for Nozzle Damage Increase Injection Pressure Increase Stock Temperature Increase Shot Size Increase Mold Temperature Check Non-Return Valve and Barrel for Excessive Wear or Damage Surface Burning of Parts Surface Burning of Parts Can Be Caused by Too High a Stock Temperature. Excessive Shear Heating Caused by Too High a Back Pressure is Also a Possible Cause. Check to Make Sure that the Venting of the Mold is Adequate. When a High Injection Speed is Used to Overcome Flow Restrictions, Frictional Burning Can Result. Surface Burning of Parts Ways to Minimize Surface Burning Decrease the Stock Temperature Decrease Injection Speed Check Venting of the Mold Enlarge Gates Check Sprue for Burning and/or Purge Shot Check Clamp Pressure Check Venting Decrease Injection Speed Decrease Injection Pressure Check Stock and Mold Temperatures Weld Lines Weld lines Occur When Two or More Melt Fronts Merge. Typically, These Will Be Melt Fronts from Different Gates, or a Single Melt Front Forced to Split Around an Obstruction Such as a Core pin. Splay Silver Streaking 銀條紋 Splay or Silver Streaks are the result of moisture on the