毕业设计（论文）--箱体注塑模CAD和CAM.doc

毕业设计（论文）报告 箱体注塑模CAD/CAM 摘要 本设计为箱体注塑模的设计。设计中采用一模两腔，浇口采用潜伏式浇口，分型面选在截面最大处，塑件成型后利用推杆将成型制品从动模上推出，回程时利用复位杆复位。 设计中需要对塑件的尺寸进行计算，确定尺寸精度，然后进行注射机的选取。对注射机参数进行校核，各个参数都满足要求后确定注射机。在设计过程中，为了更清楚的表达模具的内部结构，This design is the design of injection mould for the cabinet. The design uses two mold cavity, type of the sprue is latent gate, the parting surface is chosen in the maximum section of the plastics. After plastics are molded， molding products are driven by putting from dynamic model,then using reset stem returned. In the design ,the size of the plastic parts needed to calculate ,then determine the size precision and select the type of injection moulding machine. Checking the parameters of injection machine, including the thickness of mold closing,the size of mould installation,the trip of opening mold ,the clamping force of injection machine,and so on. Determining the model of injection machine after each parameter are meet the requirements. Finally use the UG software to mill out molding parts. In the design process , in order to express the internal structure of mould clearly，there have a lot of mould structure and mould local charts ，then through CAD and Pro/E software plot its 2d, 3d stereo. Key words：?CabinetParting surface Runner Process analysis 目录 前言·················································· (4) 1.1应用背景及意义··········································· (4) 1.2论文设计内容············································· (4) 1.3论文设计重点、难点······································· (4) 方案论证·············································· (5) 2.1 结构分析··············································· (5) 2.2 成型工艺分析··········································· (5) 2.3 生产规模··············································· (6) 箱体注射模结构设计··································· (7) 3.1成型零件设计············································ (7) 3.2浇注系统设计············································ (9) 3.3推出机构的设计·········································· (10) 3.4排气系统的设计·································