大产量臭氧发生器电源的研究及电源主回路设计.pdf

臭氧发生器电源主回路的设计 摘 要 臭氧作为一种广谱灭菌和强氧化剂的应用越来越广。然而在实际应用中 由于臭氧发生器所使用是高压脉冲电源，易受环境因素的影响，性能不稳定， 可靠性差，能耗高，影响了臭氧技术的应用。本文设计的是大产量臭氧发生 器电源的研究及电源主回路设计。传统的臭氧发生电源采用可控硅作为功率 开关器件，但是，用可控硅作为功率开关器件有很多弊端，因此设计的臭氧 发生电源应采用一种新型的功率开关器件——IGBT ，以取代传统的可控硅电 路。IGBT 全桥逆变电路采用移相式 PWM 控制方式，可实现零电压开通与关 断，过电流保护部分中的电流检测采用霍尔电流检测元件。该元件反应速度 快，设计方便。因此，该设计能满足臭氧发生器电源大功率，高性能稳定性， 高效率的要求。 关键词：臭氧发生器，逆变电源，IGBT，霍尔传感器 I 臭氧发生器电源主回路的设计 Abstract Resently,ozone is used widely as a nantiscptic and oxide in the field of environment. However, because of the surrounding factors, the stability and reliability of this high-voltage power are very low and the consumption is very high, hampering the application of ozone. This text design is studying of big outcome ozone generator power supply and power supply owners return circuit design . The ozone power supply occurs tradition uses the silicon controlled rectifier as the merit rate switching element , but , as the merit rate switching element there are a lot of malpractices with the silicon controlled rectifier . The ozone of design should use one kind of new merit rate switching element -IGBT, in order to replace traditional silicon controlled rectifier circuit therefore occurring the power supply . Bridges IGBT inversion circuit using phase shift type PWMs control mode can be realized that the zero voltage is removed obstacles from and Guan Duan , and the current crossed in the current protection part is tested and is used Huo Ers current checkout component . This component reaction speed