基于PCPLC通信的摩擦焊机网络控制系统.pdfVIP

第42 卷 第6 期 Vol．42 No．6 20 12 年6 月 Electric Welding Machine Jun．20 12 基于PC-PLC通信的摩擦焊机 网络控制系统 张 静，杜随更，马朝杰 (西北工业大学现代设计与集成制造技术教育部重点实验室，陕西西安 710068) 为适应目前工业控制系统网络化的发展，降低控制系统成本，建立了一种摩擦焊机网络控制系 摘要： 统，并进行串口通信实时性和稳定性的研究。主控制站采用工业控制计算机(IPC)，从控制站采用三菱FX 系列可编程控制器(PLC)，计算机闭环控制过程中的开关量信号通过串口通信在两站间实时传送。测试 结果表明：网络性能与串口通信程序的优化程度、PLC 性能和通信速率密切相关。若采用FX3U PLC，通信 速率115．2 kbps，通信过程约在5．8 ms 完成。现场应用表明，采用此网络控制系统，摩擦焊机系统的运行 速度高、投资小、系统运行稳定可靠。 摩擦焊机；网络控制；串口通信；实时性 关键词： TG409 ；TG438 A 1001－2303(2012)06－0035－04 中图分类号： 文献标识码： 文章编号： Networked control system of friction welding machine based on PC－ PLC communication ZHANG Jing ，DU Sui－geng，MA Zhao－jie (The Key Laboratory of Contemporary Design and Integrated Manufacturing Technology ，Ministry of Education， Northwestern Polytechnical University ，Xian 710068 ，China) ： Abstract To accommodate the developing of the networked industrial control system ，and to reduce the cost of hardware of the control system ，networked control system of friction welding machine was set up ，then real－time and stability of serial port communication was researched．The main control station is the industrial control computer，and the subordinate control station is Mitsubish FX Programmable Logic Controller．The digitalsignals in the process of computer closed－loop control system are transmitted through serial communication between two stations in real －time．Data statistical analysis showed that networked performance is closely related with optimization degree of serial port communication program ，PLC performance and communication