【环境工程专业】【毕业论文+开题报告+文献综述】日处理60吨4B酸生产废水的工艺及工程设计.doc

（20 届） 毕业设计 日处理60吨4B酸生产废水的工艺及工程设计 摘 要 针对4B酸废水具有的色度高、生化指标差的特性，在资料分析的基础上，运用树脂吸附技术，确定设计方案，并进行理论计算分析。本设计采用调节池对污水进行预处理后通过提升泵房后用树脂吸附法对4B酸进行吸附，完成吸附后的废水通过中和曝气池对吸附废水进行中和处理，中和后的上清液排入集水池，集水池中的污水沉降后排入城市污水管网，中和后的污泥输送至污泥浓缩池进行浓缩处理。结果表明，该组合工艺对4B酸废水的色度、CODcr,有良好的处理效率，进水水质为COD浓度为10000-12000mg/L，色度200倍左右，pH值为1-2，出水水质为COD浓度为400mg/L，色度在20倍左右，pH值为6-9，其中COD的去除率达到90%以上，色度的去除率为90%，且对废水中的4B酸进行回收，每吨4B酸废水中能够回收5kg，经过中和处理后的出水水质达到《污水综合排放标准》(GB8978-96)  4B daily processing 60 tons of acid production process and engineering design of wastewater Abstract 4B acid for wastewater with high color, poor biochemical characteristics, based on data analysis, using resin adsorption techniques to determine the design and theoretical calculation. The design uses a regulation pool after pretreatment of sewage pumping station for later use by increasing resin acid adsorption method 4B, after completion of the wastewater through the adsorption and aeration tanks in wastewater on the adsorption and treatment, during and after the last Clear liquid into the collecting tank, set a sewage pond after settling into urban sewage pipe network, during and after the sludge transported to the sludge thickener for enrichment processing. The results show that the combined process of acid wastewater 4B chroma, CODcr, good efficiency, water quality for the COD concentration of 10000-12000mg / L, about 200 times the color, pH value of 1-2, the water quality The COD concentration of 400mg / L, about 20 times in color, pH value of 6-9, where the removal rate of COD reached 90%, and color removal rate was 90%, and the 4B acid wastewater For recycling, waste water per ton of acid can be recovered 4B 5kg, and after the treatment, the effluent quality to the national Integrated Wastewater Discharge Standard(GB8978-96) in the three standard. Can be discharged into urban sewage pipe network, for further processing.显示对应的拉丁字符的拼音 Keywords: Resin adsorption; 4B acid wastewater; in and aeration tank; regulation pool? 字典 朗读 显示对应的拉丁字符的拼音 ?