外文翻译--一种采用现代先进控制算法的3轴台式数控系统铣床.docVIP

Development of a 3-axis Desktop Milling Machine and a CNC System Using Advanced Modern Control Algorithms Byung-Sub Kim，Seung-Kook Ro and Jong-Kweon Park 1Nano Convergence Manufacturing Systems Research Division, Korea Institute of Machinery Materials, Daejeon, South Korea, 305-343 Corresponding Author / E-mail: bkim@kimm.re.kr, TEL: +82-42-868-7109, FAX: +82-42-868-7180 In this paper, we introduce a desktop-size 3-axis milling machine and a CNC system which was developed to operate the 3-axis milling machine. The 3-axis milling machine has a mini-desktop size of 200×300×200 mm3 and its cutting volume is 20×20×20 mm3. The vertically installed XY stage is driven by voice-coil motors, and for the z-axis, a magnetically preloaded air bearing and a linear motor are used. The air spindle runs at up to 160,000 rpm. The gravity force is acting on the y-direction, so a weight balancer using an air bearing cylinder is installed to cancel out the gravity force acting on the XY stage in the y-direction. The CNC system designed for the 3-axis milling machine consists of two parts. The one is a graphical user interface program which runs under Microsoft Windows and the other is a DSP program which is implemented on a DSP board with TI TMS320C6701 chips. A G-code interpreter is included in the CNC system which can interpret and interpolate a basic set of G-codes and M-codes in real-time. To improve the performance of servo control loop in the CNC system beyond the traditional PID-type control, several modern control algorithms have been tested including control, input shaping control, disturbance observer and cross-coupled control on the 3-axis milling machine. Experimental results show the effectiveness and drawbacks of each control scheme when they are applied to the 3-axis desktop milling machine. KEYWORDS: 3-axis milling machine, CNC system, H control, Input shaper, Cross-coupled control 1. Introduction As new fields such as IT(Information Technology), BT(Bio Technology) an