【电子信息工程毕业设计+文献综述+开题报告】基于无线通信的点菜系统设计.doc

（20_ _届） 本科毕业设计 基于无线通信的点菜系统设计 摘 要 无线点餐系统的实现主要是要靠无线通信技术，将两片单片机作为无线通信的发送和接收端设备，无线通信技术遵循TCP协议，TCP协议是一种连接导向的、可靠的、基于字节流的运输层通信协议。在整个点餐的过程中，由单片机进行按键选择输入，然后选择的结果会在电脑的界面上展现出来，电脑上面展示的界面使用VB语言进行开发，程序的编写选择使用C语言，因为相对于其他语言来说C语言比较简单易懂。编写程序的时候选择分模块进行，在一个主程序中分别调用各个分模块，比如有选择的模块、发送的模块等等，这样分模块进行的好处就在于整个程序便于调试，最后程序的实现是通过KeilC51烧入单片机之后来完成的。 文章首先分析了无线点餐系统的组成以及各个部分的功能，并对硬件设备进行简要的设计分析。然后再对几种无线通信方式进行比较后，得出应该采用微功率短距离的无线通信技术，并且详细分析所采用的TCP协议。最后是软件的开发，采用C语言编程，在主程序中进行子程序调用，增加程序的可阅读性和可修改性，大大缩短了程序的调试周期。 关键词：无线通信，TCP协议，模块，单片机，C语言 Design of Order Dishes System Based on Wireless Abstract Wireless ordering system mainly depends on the realization of wireless communications technology, two pieces of MCU become the wireless communications sending and receiving terminal equipment. Wireless communication technology follows the TCP protocol, TCP protocol is a connection_oriented, reliable, byte stream_based transport layer communication protocol. In the process of the whole order, key to select the input from the MCU, then select the results will show up on the computers interface, we use VB language to develop this. Programs choose to use C language writing, as compared to other languages, C language is relatively simple to understand. When writing a program, we choose points module. In a main program calls each sub-module, respectively. For example have choice of module, send module, etc. The benefits of this sub-module is that the entire process easy to debug. Finally, program implementation is downloaded into the MCU by KeilC51 was completed. First, this article analyses the composition of ordering system of wireless and the function of each part, and the design of hardware device briefly analysed. Then compared the other wireless communications, we found that we should use the micro-power short-range wireless communication technology, and analysed the TCP protocol detailedly. Finally, we use C language to develop the program. The advantage is easy to read and