解析燃气烘炉火焰检测不稳定改造.docVIP

解析燃气烘炉火焰检测不稳定改造 【摘要】本文是以烘炉燃烧时火焰检测设备的故障全过程为实例,探讨分析影响烘炉火焰检测稳定的各种因素,详述与之相对应的检修对策及效果,说明通过改进修检工艺,可以有效地提高烘炉灭火保护装置的可靠性。 【 abstract 】 this article is based on oven burning flame detection equipment failure process as an example, analyzes factors which influenced the stability of the oven flame detection, detail and the corresponding repair measures and effect, and that by improving the inspection process, can effectively improve the reliability of oven fire protection device. 　　【关键词】电离电极;火焰监测器;程序控制器;稳定性 【 key words 】 the ionization electrode; Flame monitor; Program controller; The stability 　　　　 　　1 前言 1 introduction 　　 　　笔者对广州某公司在运转的三台烘炉进行了半年时间的观察及检测,发现了因设计、安装质量、检修调整、燃烧工况(调整)等诸多问题,炉膛外火焰检测信号长期不稳定,多次出现保护误动现象,严重影响了机组的安全稳定运行。一方面火检装置本身存在不稳定因素,另一方面燃烧控制设备可控性差;燃烧调整不当又反过来影响火检的稳定,并多次影响工作效率,本文就怎样对烘炉火焰检测改造进行探讨。 The author a company working in guangzhou three oven for half a years observation and testing, found due to the quality of design, installation, maintenance adjustment (adjustment), combustion conditions and so on many issues, outside the furnace flame detection signal is not stable for a long time, multiple occurrences of protection misoperation phenomenon, seriously affecting the safe and stable operation of the unit. Fire detection device itself exists unstable factors on one hand, on the other hand, poor combustion control equipment control; Improper combustion adjustment, in turn, influence the stability of the flame detector, and influence work efficiency many times, this article on how to oven flame detection transformation were discussed. 　　 　　2 影响火检稳定的因素分析 Two factors affecting the stability of the flame detector is analyzed 　　 　　从烘炉设备分析火检不稳定原因应从火检装置本身和燃烧变化两个方面进行分析,找出制约火检光(电)信号传输、处理不合理环节和燃烧工况变差的因素,并采取有效的检修对策改进设备、燃烧控制以及改善调整,完全可以消除锅炉火检不稳定现象,这在1号、2号炉改造后15个火检的良好运行工况得到了证明。 From oven equipment this paper analyzes the reasons of unstable flame detector should from the device itself and the combustion flame detector changes two aspects carries on the analysis, find the fire de