ch傅里叶表示的应用(Fourierrepresentationsforsignals).pptVIP

Ch4 混合信号中傅里叶描述的应用(Applications of Fourier representations to mixed signals) Ch4.1 引言（Introduction） Ch4.2 周期信号的傅里叶描述 （Fourier Transform of Periodic signals) Ch4.2.1 Fourier Transform of continuous-time Periodic signals连续时间周期信号的傅里叶描述 Ch4.2.2 Fourier Transform of Discrete-time Periodic signals（离散时间周期信号的傅里叶表示） Ch4.3 Convolution Modulation of Mixed Signals（混合信号的卷积与调制） Example：Amplitude Modulation Ch4.4 Fourier Transform of Discrete-time signals（离散信号的FT表示） Ch4.5 Sampling of continuous time (CT) signals（连续时间信号的抽样） Theoretical derivation of sampling theorem Theoretical derivation of sampling theorem Theoretical derivation of sampling theorem Theoretical derivation of sampling theorem 抽样定理(Sampling Theorem) Practical Applications of Sampling Theorem Practical Applications of Sampling Theorem Practical Applications of Sampling Theorem Conclusions Discussion Ch4.6 Reconstruction of continuous-time signals from samples （从取样点重建原连续信号） Reconstruction of continuous-time signals from samples （从取样点重建原连续信号） Reconstruction of continuous-time signals from samples （从取样点重建原连续信号） Reconstruction of continuous-time signals from samples （从取样点重建原连续信号） From the above, we learned the key technique about signal sampling. The mathematic description of signal sampling is: This is just an abstract mathematic model and cannot be applied in practice. In practical engineering, there are several chips to implement sampling. To meet different requirements, each chip has its own parameters, the basic parameters are: Aliasing and truncation（混叠和截断） In general, if x ( t ) is sampled below the Nyquist rate x( t ) cannot be recovered from its samples. Two types of errors occur ---- aliasing(混叠) in which a high frequency component of the signal appears (under an alias) at a lower frequency, and truncation(截断) in which high frequency components of the signal are filtered out. fs= 2fm 为最小抽样频率，称为Nyquist Rate. ωs ? 2ωm （或 fs ? 2fm ） 若带限信号x(t)的最高角频率为ωm，则在满足一定条件下,信号x(t)可以用等间隔T的抽样值唯一表示。