Chapter 10Sinusoidal Steady State Analysis.ppt

Chapter 10Sinusoidal Steady State Analysis Transform the circuit to the phasor or frequency domain. Solve the problem using circuit techniques (nodal analysis, mesh analysis, superposition, etc.). Transform the resulting phasor to the time domain. a) All sources except DC 5-V set to zero c) All sources except 2 sin 5t set to zero * Eeng 224 Huseyin Bilgekul Eeng224 Circuit Theory II Department of Electrical and Electronic Engineering Eastern Mediterranean University Chapter Objectives: Apply previously learn circuit techniques to sinusoidal steady-state analysis. Learn how to apply nodal and mesh analysis in the frequency domain. Learn how to apply superposition, Thevenin’s and Norton’s theorems in the frequency domain. Learn how to analyze AC Op Amp circuits. Be able to use PSpice to analyze AC circuits. Apply what is learnt to capacitance multiplier and oscillators. Steps to Analyze AC Circuits Transform the circuit to the Phasor Domain. Solve the problem using circuit techniques listed below Nodal Analysis Mesh Analysis Superposition Source transformation Thevenin or Norton Equivalents Transform the resulting circuit back to time domain. Steps to Analyze AC Circuits Time to Freq Solve Variables in Freq Freq to Time Nodal Analysis Since KCL is valid for phasors, we can analyze AC circuits by NODAL analysis. Determine the number of nodes within the network. Pick a reference node and label each remaining node with a subscripted value of voltage: V1, V2 and so on. Apply Kirchhoff’s current law at each node except the reference. Assume that all unknown currents leave the node for each application of Kirhhoff’s current law. Solve the resulting equations for the nodal voltages. For dependent current sources: Treat each dependent current source like an independent source when Kirchhoff’s current law is applied to each defined node. However, once the equations are established, substitute the equation for the controlling quantity to ensure that the unknown