500kV断路器合闸回路故障引起的保护误动事故分析.pdfVIP

500kV 断路器合闸回路故障引起的保护误动事故分析 1 2 1 1 1 刘涛 ，李凤旭 ，屈延师 ，黄克选 ，余开伟 （1.河南省电力公司检修公司，河南 郑州450051 ；2.华能玉环电厂，浙江 玉环县 317604 ） 摘要：针对一起3/2 接线的500kV 输电工程继电保护误动作情况，判断为变电站侧 先合断路器重合闸不成功所致。通过变电站侧现场对断路器控制回路的检查与分析， 发现为该合闸回路中的联锁回路设计不合理而导致的保护误动作，同时探讨了该合 闸控制回路、TWJ 继电器监视回路和合闸联锁回路设计原理及其优缺点，最后提出 了该回路的改进方案。先合断路器重合闸闭锁后合断路器重合闸设计是本次事故的 次要原因，文章对此功能的优缺点进行了分析，提出了改进方案。本文对断路器控 制回路的设计有借鉴和指导意义。 关键词：重合闸;断路器控制回路;TWJ;合闸联锁 Fault Analysis on an Incorrect Relay ActionCaused by Closing Operation Circuit Malfunction of the 500kV Power Breaker 1 2 1 1 1 LIU-Tao , LI Feng-xu , QU Yan-shi ,HUANG Ke-xuan ,YU Kai-wei (1.Maintenance Company of Henan Electric Power Corporation, Zheng Zhou, 450051, China; 2.Huaneng Yuhuan Power Plant,Yuhuan,317604,China) Abstract: Based on an incorrect action of 3/2 wiring 500kV transmission line relay system, it was sentenced to the failure of the first closing breaker action in substation side. According to the check and analysis of the scene, it was sentenced to that the fault was caused by unreasenable design of the closing operation circuit. This paper researches the design principles and its characteristics of the closing operation circuit ， TWJ relay monitoring circuit and its interlocking circuit, several improved schemes are presented on this question simultaneously. The design that later reclosing breaker is locked by first reclosing breaker is the second reason of this incorrect action. Based on this design, improved scheme is presented. It has some steering meaning for design of power breaker