毕业设计（论文）-接触环零件的冲压模具设计.doc

毕 业 设 计 课题：接触环零件模具设计 院系：材料科学与工程 专业：模具设计与制造 姓名： 班级： 指导老师 ： 接触环零件的冲压模具设计 摘 要 冷冲压是利用安装在压力机上的冲模对材料施加压力，使其产生分离或塑性变形，从而获得所需零件（俗称冲压件或冲件）的一种压 力加工方法。该零件包括冲孔和落料两个基本工序，由于零件大批量生产，因此采用级进冲裁，这样生产效率高，操作方便，通过设计合理的模具结构和排样方案可以达到较好的零件质量和避免模具强度不够的问题。该零件材料厚度较薄，尺寸小，近似T形，因此采用45度的斜对排样。为了便于操作和保证零件的精度，宜采用导料导向，侧刃定距的定位方式。考虑零件厚度较薄，采用弹性卸料方式， 为了便于操作，提高生产率，冲件和废料采用由凸模直接从凹模具洞口推下的出件方式，由于零件厚度薄，冲裁间隙很小，又是级进模，因此采用导向平稳的对角导柱模架。 ［关键词] 级进模 排样 冲孔 落料 ABSTRACT [Keywords] Level enters a model Row Bore Fall The dint processes a method.That spare parts includes blunt bore and falls to anticipate two basic work prefaces, because the spare parts large quantity quantity produce, so adoption the class enter hurtle to cut, so produce an efficiency high, operation convenience, pass a design reasonable of molding tool structure and line up the kind project and can attain better spare parts quality and avoid a not enough problem of the molding tool strength.The spare parts material thickness is thinner, the size is small, looking like a T form, so adopt 45 degrees inclined to the rows kind.For the sake of the accuracy of the easy to operation and assurance spare parts, the proper adoption leads to anticipate a direction, the side blade certainly is apart from of fixed position method.Consider the spare parts thickness thinner, adopt flexibility to unload to anticipate a way, For the sake of the easy to operation, the exaltation rate of production, the blunt piece and the waste adoption from convex mold direct from the cave molding tool entrance to cave push bottom of piece method, because the spare parts thickness is thin, hurtling to cut cleft very small, and then is a class into the mold, so the adoption lead to steady opposite angles to lead a pillar mold. 目 录 摘要........................................................... 前言........................................................... 第一章 冲压概述............................................... 第二章 零件的工艺分析及方案的确定............................. 2.1 零件的工艺分析.