毕业设计（论文）-电气接线管塑料注射模设计.doc

 电气接线管塑料注射模设计 系 别：机电与自动化学院 专 业 班：0701班 姓 名：XXX 学 号：2007XXXXX 指导教师：XXXX 2011年6月 电气接线管塑料注射模及动定模加工工艺设计 The Disign of Plastic injection molding for Electronic Connection Pipeline and moving and stationary mold processing technology 摘 要 塑料注射成型技术是根据压铸原理从十九世纪末二十世纪初发展起来的，是目前塑料加工中最普遍采用的方法之一。该法适用于全部热塑性塑料和部分热固性塑料因此，注射装置必须保证塑料均匀塑化，并有足够的注射压力和保压压力。能满足这些要求的注射装置主要有柱塞式、柱塞—螺杆式、螺杆式等。塑料注射成型螺杆Abstract Plastic injection molding technology is based on the principle of die-casting from 19th century and the early twentieth century developed, is currently the most widely used processing plastic one way. The method applies to all thermoplastics and parts of thermosetting plastic In injection molding, plastic particles by neutral from hopper into heat barrel. When screw plunger will plastic particles slow advance, plastic is advancing can make the melting of heating chamber. Because the plunger moving forward, melting plastic oppression by opposite the mould of nozzle, sprue and hot word systems into a cavity. Mould keep cooling, thus mould once be filled, plastic began to solidify. Resin or note billet model of the raw material, usually in pills or particle forms are provided. Resin balls into a great leakage at the bottom of the hopper, hopper and cylindrical level material barrel connections. In a nitrogen-treated barrel within the screw by motor rotation, raw materials particles will screw thread slot fill. The screw thread depth to one end of the mould has heating decreases, compression plastic. When screw rotation, plastic particles by screw drive advance, and bear melting needed extreme pressure and friction. In the process of melting, during the external nitrogen-treated barrel with resistanse wire to assist in heating and temperature control. Therefore, plastic injection unit must ensure uniform plasticizing, and have enough injection pressure and holding pressure. Can meet these requirements of injection equipment mainly have piston type, plunger -- screw, screw, etc. Ke